Adjusting The Chassis; Handlebar Position - SHERCO 250 SEF/R Owner's Manual

250-300 SEF/R

Adjusting the chassis

HAndLeBAR POSiTiOn

A
B
90
The triple clamps have two holes separated by a
distance A.
Distance between holes A
The handlebar clamps are offset by a distance B
Handlebar offset B
The bike comes standard with the handle-
bars in the rear most position.
Remove the four screws
bar top clamps and remove the handlebar.
Remove the two screws
clamps and place them in the desired position.
Handlebar
lower clamp
Replace the handlebars and top clamps. Replace
the four screws
Handlebar clamps
fixing screws
The handlebars can be rotated forward and
rearward in the clamps.
1
2
13mm
. Remove the handle-
1
. Remove the lower
2
M10x35 40Nm Loctite
and tighten evenly.
1
M8x25
4mm
243
® ™
24Nm