Electrical System Maintenance; Removing The Battery - SHERCO 250 SEF/R Owner's Manual

250-300 SEF/R
Brakes (continued)
2

electrical system maintenance

ReMOvinG THe BATTeRY

2
114
1
1
3
Install the new pads.
Reinstall the retaining pins
Check the brake fluid level and fill if necessary.
( p.48 et p. 49)
☛
ATTenTiOn
Do not use the bike until the brake lever and the pedal
are operational. «Pump» the brake lever / brake pedal
up and down until the brake pads are in contact with
the discs.
Turn off all electric devices and stop the engine.
ATTenTiOn
- 250-300 SEF (standard): Confirm that the key start
is in the OFF position.
- 250-300 SEF/R (racing): Confirm that the on / off
switch is in the OFF position.
If this is not done there is a significant risk of
damage to the computer (ECU).
- Remove the seat (
☛
- Remove the air filter (
- The battery is located at the bottom of the filter
housing.
- Remove the two screws
battery retaining bracket.
- Disconnect the negative cable from the battery
- Disconnect the battery positive cable
- Remove the battery from the top.
and clips
2 1
p.34)
p.34).
☛
that retain the
1
.
3
.
2