Unpacking Your Refrigerator; Required Tools - Kenmore 65702 Use & Care Manual

WARNING
Excessive Weight Hazard
Use two or more people to move and install the
refrigerator. Failure to do so can result in back or
other injury.

UNPACKING YOUR REFRIGERATOR

Remove tape and any temporary labels from the
refrigerator before using. Do not remove any warning-
type labels, the model and serial number label, or the
tech sheet that is attached to the back wall of the
refrigerator.
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleansers to remove tape or glue. These
products can damage the surface of the refrigerator. For
more information, see the Important Safety Instructions sec-
tion.
Refrigerator shelves are installed in the shipping position.
Please reinstall the shelves according to your individual stor-
age needs.
CAUTION
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the
refrigerator for cleaning or service, be sure to protect the
floor. Always pull the refrigerator straight out when moving
it. Do not wiggle or walk the refrigerator when trying to
move it, as floor damage could occur.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from the refrigerator. Failure to do
so can result in death, explosion, or fire.
• To reduce the risk of electric shock, do not install
the refrigerator in a wet or damp area.
• Select a place where a water supply can be easily
connected for the automatic icemaker.
DA68-01921B.indb 10
REFRIGERATOR INSTALLATION
Avoid placing the refrigerator near a heat source,
direct sunlight, or moisture.

REQUIRED TOOLS

The following tools are needed to install and adjust
the refrigerator.
10 10
CAUTION
Phillips-Head Flat-Head
Screwdriver (+) Screwdriver (–)
Hex Wrench
3/16 in. (4.75 mm)
(for middle hinge shaft)
(for middle hinge)
Socket Wrench
13/32 in. (10 mm)
(for bolts)
Hex wrench
5/32 in. (4 mm)
2010.3.5 9:26:40 AM