DAELIM S4 50cc Service Manual page 174

STARTING SYSTEM
STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH
STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH
STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH
STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH STARTER MAGNETIC SWITCH
STARTER MAGNETIC SWITCH
REMOVAL
● Remove the luggage box.
● Remove the battery (+) cable from the starter
magnetic switch terminal.
● Remove the starter motor cable from the starter
magnetic switch terminal.
● Disconnect the coupler connected to wire harness,
and starter magnetic switch.
INSPECTION
● Check if the starter magnetic switch "click" when it
is turened ON.
- Click but the engine does not start.
→ Poorly connected battery terminal and motor
terminal of the switch. (Check the starter
magnetic switch)
- No click → No starter magnetic switch input
voltage. (Faulty relay ground line and starter
magnetic switch)
STARTER MAGNETIC
VOLTAGE
● Measure the voltage between the yellow / red wire
(+) and ground at the starter magnetic switch
connector.
● If battery voltage appears only when the starter
switch is pressed, it is normal.
● Check the resistance between terminals of starter
magnetic switch.
OPERATION CHECK
● Disconnect the magnetic switch wire connector.
● Apply battery voltage between trminals, when the
yellow / Red wire is connected to the positive (+)
battery terminal and the yellow / Green wire to the
negative (-) battery terminal. If there is continuity
between battery and motor terminal, it is normal.
● Install in the reverse order of removal.
SWITCH