Oki c911 Disassembly & Reassembly Procedures page 34

CAUTION:
cables are easily damaged. Make sure you
unlock the board / head connector tabs
before you remove / reinstall the head
cables. Damaged cables will cause errors
on power up.
As you can see, the cable at the right has 3
damaged connectors – and the only
solution is to replace the damaged cable.
There are 20 wire harness cables to
87
disconnect.
Gently unplug all harnesses and cables
88
from the main logic board.
NOTE:
Pay attention to how the
wires are routed to and through the
card cage for re-assembly procedures.
The LED Print Head
32