Rear Seat And Cargo Platform Operation; 12-Volt Power Outlet - Cushman SHUTTLE 2+2 G Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

Rear Seat and Cargo Platform Operation

To prevent damage to the rear seat, move any accessories that are
installed on the hand rail, when you fold the seat.
Fold the seat to the flat position to access the cargo platform.
Secure the loads on the platform to prevent movement.
Put the load on the platform as far forward as possible.
The center of gravity of the load must be less than 4 inches
(10 cm) above the platform.
Do not put more than the specified capacity on the platform.
Increased loads can change drive properties of the vehicle.
Do not allow passengers to ride on the cargo platform.
When you put cargo on the platform, make sure you follow information
below to decrease the risk of injury, damage to the vehicle or cause the
vehicle to tilt over.
• Put the load on the platform as far forward as possible.
• Secure the loads on the platform to prevent movement.
• The center of gravity of the load must be less than 4 inches (10 cm)
above the platform.
• The load capacity of the cargo platform is a maximum of 250 lbs. (115 kg). Do not put more than the specified capac-
ity on the platform.
Increased loads can change the drive properties of the vehicle.

12-Volt Power Outlet

Overuse of accessories can drain the battery and leave insufficient charge to
Excessive use of accessories that are connected to the outlet can drain the
Lift the cover and insert the 12-volt accessory plug.
start the vehicle.
battery.
Owner's Guide
OPERATING PROCEDURES
REAR SEAT FOLDED DOWN
REAR SEAT FOLDED UP
Power Outlet
B
21