Troubleshooting - Stanley JS900CS Instruction Manual

• Excessive engine cranking can damage the vehicle's starter motor. If the engine fails to start after the recommended number of
attempts, discontinue jump-start procedure and look for other problems that need to be corrected.
• If the connections to the battery' s positive and negative terminals are incorrect, the Reverse Polarity Indicator will light and the unit
will sound a continuous alarm until the clamps are disconnected. Disconnect clamps and reconnect to battery with correct polarity.
• If vehicle fails to start, turn off the ignition, turn off the Jump-Starter Power Switch, disconnect the jump-start system' s leads and
contact a qualified technician to investigate why the engine did not start.
• Recharge this unit fully after each use.
12 VOLT DC PORTABLE POWER SUPPLY
The 12 volt DC accessory outlet is located under a protective cover on the top of the unit. This portable power source is for use with
all 12 volt DC accessories equipped with a male accessory outlet plug that are rated up to 5 amps.
1. Lift up the cover of the unit 's 12 volt DC outlet.
2. Insert the 12 volt DC plug from the appliance into the 12 volt accessory outlet on the unit. DO NOT EXCEED A 5 AMP LOAD.
3. Switch on the appliance and operate as usual.
4. Periodically check the unit' s battery status by pressing the battery power level button. (When all three battery status indicators
light, it indicates a full battery. When only one red battery status indicator lights, it indicates that the unit needs to be
recharged.)
USB CHARGING PORT
The USB charging port is located under a protective cover on the left side of the main control panel.
1. Push the USB Power Button to turn the USB Charging Port on and the USB power indicator will light.
2. Lift up the cover of the USB Charging Port.
3. Plug the USB-powered device into the USB Charging Port and operate normally.
4. Periodically check the unit' s battery status by pressing the battery power level button. (When all three battery status indicators
light, it indicates a full battery. When only one red battery status indicator lights, it indicates that the unit needs to be
recharged.)
Notes:
This unit' s USB Power Port does not support data communication. It only provides 5 volts/500mA DC power to an external USB-powered device.
Make sure the USB Power Button is in the off position when the unit is being recharged or stored.
Some household USB-powered electronics will not operate with this unit.
LED AREA LIGHT
The area light is controlled by the LED Light Power Button on main control panel. Make sure the area light is turned off when the
unit is being recharged or stored.
Periodically check the unit' s battery status by pressing the battery power level button. (When all three battery status indicators
light, it indicates a full battery. When only one red battery status indicator lights, it indicates that the unit needs to be recharged.)
PORTABLE COMPRESSOR
The built-in 12 volt DC compressor is the ultimate compressor for all vehicle tires, trailer tires and recreational inflatables. The
compressor hose with tire fitting is stored in a retaining channel on the back of the unit. The On/Off Switch is located on the rear of
the unit under the air pressure gauge. The compressor can operate long enough to fill up to 3 average sized tires before the battery
must be recharged.
The compressor may be used by removing the air hose from the storage compartment and if required, fitting an appropriate nozzle
to the air hose. Return hose to the storage compartment after use.
Inflating Tires or Products With Valve Stems
1. Screw the SureFit™ nozzle connector into the valve stem. Do not overtighten.
2. Turn on the Compressor Power Switch.
3. Check pressure with the pressure gauge.
4. When desired pressure is reached, turn off the Compressor Power Switch.
5. Unscrew and remove the SureFit™ nozzle connector from the valve stem.
6. Allow the unit to cool before storing away.
7. Store the compressor hose and nozzle in the storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of one of the nozzle adapters.
1. Select the appropriate nozzle adapter (i.e, needle).
2. Screw the adapter into the SureFit™ nozzle connector. Do not overtighten.
3. Insert the adapter into item to be inflated.
4. Turn on the Compressor Power Switch — inflate to desired pressure or fullness.
IMPORTANT NOTE: Small items such as volleyballs, footballs, etc. inflate very rapidly. Do not over-inflate.
5. When desired pressure is reached, turn off the Compressor Power Switch.
JS900CS_ManualENSP_022514.indd 8-9
8
6. Disconnect the adapter from the inflated item.
7. Unscrew and remove the adapter from the SureFit™ nozzle connector.
8. Allow the unit to cool before storing away.
9. Store the compressor hose, nozzle and adapter in the storage compartment.
WARNING: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: FOLLOW ALL SAFETY INSTRUCTIONS FOUND IN
THE "SPECIFIC SAFETY INSTRUCTIONS FOR COMPRESSORS" SECTION OF THIS INSTRUCTION MANUAL.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use, we
recommend that the battery is charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the unit with a soft cloth moistened with a mild
solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer to
replace any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a number of factors including but not limited to
the number of recharge cycles, and proper care and maintenance of the battery by the end user. Contact manufacturer for any
information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal regulations can result in fines or imprisonment. Contact
your local waste management authority to dispose of this product.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.

TROUBLESHOOTING

Unit will not charge
• Make sure all of the unit' s functions are turned off.
• Make sure a suitable gage extension cord is properly connected to both the unit and a functioning AC outlet.
Unit Fails to Jump-Start
• Make sure unit' s power switch is in the on position.
• Check that jump-starter has a full charge. Recharge unit if necessary.
• Make sure a proper polarity cable connection has been established.
12 volt DC portable power supply will not power appliance
• Make sure the appliance does not draw more than 5 amps.
• Check that jump-starter has a full charge. Recharge unit if necessary.
USB Power Port will not power appliance
• Make sure the USB Power Button is in the on position.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
LED Area Light does not come on
• Make sure the LED Area Light Power button is in the on position
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
Portable Compressor will not inflate
• Make sure the Compressor Power Switch is in the on position.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
• Make sure the connector nozzle is securely screwed on to the valve stem when attempting to inflate tires; or nozzle adapter is
securely inserted into SureFit™ nozzle connector on all other inflatables.
ACCESSORIES
Recommended accessories for use with your tool may be available from the manufacturer. If you need assistance regarding
accessories, please contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
PLEASE
RECYCLE
9
2/25/2014 10:46:57 AM