Advertisement
Available languages
Available languages
battery terminal or moving part. Refer to the automobile owner's
manual.
6. When clamps are connected properly, turn the Jump-Starter Power Switch to ON.
7. Turn ON the ignition and crank the engine in 5-6 second bursts until the engine
starts.
8. Turn the Jump-Starter Power Switch back to the OFF position.
9. Disconnect the negative (–) engine or chassis clamp first, then disconnect the
positive (+) battery clamp.
WARNING –
To reduce the risk of injury or property damage:
• FOLLOW ALL SAFETY INSTRUCTIONS FOUND IN THE "Specific Safety
Instructions for Jump Starters" section of this instruction manual.
• This power system is to be used ONLY on vehicles with 12 volt DC battery systems.
• Never touch red and black clamps together — this can cause dangerous sparks,
power arcing, and/or explosion.
• After use, turn the Jump-Starter Power Switch off.
CAUTION –
To reduce the risk of property damage:
• Vehicles that have on-board computerized systems may be damaged if vehicle
battery is jump-started. Before jump-starting this type of vehicle, read the vehicle
manual to confirm that external-starting assistance is advised.
• Excessive engine cranking can damage the vehicle's starter motor. If the engine
fails to start after the recommended number of attempts, discontinue jump-start
procedure and look for other problems that need to be corrected.
• If the connections to the battery's positive and negative terminals are incorrect,
the reverse polarity indicator will light and the unit will sound a continuous alarm
until the clamps are disconnected. Disconnect clamps and reconnect to battery
with correct polarity.
• If vehicle fails to start, turn off the ignition, turn off the Jump-Starter Power
Switch, disconnect the jump-start system's leads and contact a qualified technician
to investigate why the engine did not start.
• Recharge this unit fully after each use.
USB POWER PORT
1. Push the USB Power Button to turn the USB Port on and the USB power
indicator will light.
2. Lift up the cover of the USB Charging Port.
3. Plug the USB-powered device into the USB Charging Port and operate normally.
4. Periodically press the battery charge level pushbutton to check battery status.
(When all three battery status indicators light, it indicates a full battery. When
only one red battery status indicator lights, it indicates that the unit needs to
be recharged.)
Notes:
This unit's USB Power Port does not support data communication. It only provides 5 volts/2.1A DC
power to an external USB-powered device.
Make sure the USB Power Button is in the off position when the unit is being recharged or stored.
Some household USB-powered electronics will not operate with this unit.
12 VOLT DC PORTABLE POWER SUPPLY
This portable power source is also for use with all 12 volt DC accessories equipped
with a male accessory outlet plug and are rated up to 5 amps.
1. Lift up the cover of the unit 's 12 volt DC outlet.
2. Insert the 12 volt DC plug from the appliance into the 12 volt accessory outlet
on the unit. DO NOT EXCEED A 5 AMP LOAD.
3. Switch on the appliance and operate as usual.
4. Periodically press the Battery Charge Level Button to check battery status.
(When all three Battery Status Indicators light, it indicates a full battery. When
only one red battery status indicator lights, it indicates that the unit needs to
be recharged.)
EMERGENCY AREA LIGHT
The area light is controlled by the Area Light Power Switch on top of the light.
Make sure the area light is turned off when the unit is being recharged or stored.
Periodically press the Battery Charge Level Button to check battery status. (When all
three battery status indicators light, it indicates a full battery. When only one red
battery status indicator lights, it indicates that the unit needs to be recharged.)
PORTABLE COMPRESSOR
The built-in 12 volt DC compressor is the ultimate compressor for all vehicle tires,
trailer tires and recreational inflatables. The compressor hose with tire fitting
is stored in a retaining channel on the back of the unit. The On/Off Switch is
located on the rear of the unit under the air pressure gauge. The compressor can
operate long enough to fill up to 3 average sized tires before the battery must be
recharged.
J5C09CA_ManualENFR_072321.indd 6-7
J5C09CA_ManualENFR_072321.indd 6-7
The compressor may be used by removing the air hose from the storage
compartment and if required, fitting an appropriate nozzle to the air hose. Return
hose to the storage compartment after use.
Inflating Tires or Products With Valve Stems
1. Screw the Sure Fit
nozzle onto the valve stem. Do not overtighten.
®
2. Turn on the Compressor Power Switch.
3. Check pressure with the pressure gauge.
4. When desired pressure is reached, turn off the Compressor Power Switch.
5. Unscrew and remove the Sure Fit
nozzle from the valve stem.
®
6. Allow the unit to cool before storing away.
7. Store the compressor hose and nozzle in the storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of the nozzle adapter.
1. Screw the adapter into the Sure Fit
nozzle. Do not overtighten.
®
2. Insert the adapter into item to be inflated.
3. Turn on the Compressor Power Switch – inflate to desired pressure or fullness.
IMPORTANT NOTE: Small items such as volleyballs, footballs, etc. inflate very
rapidly. Do not over-inflate.
4. When desired pressure is reached, turn off the Compressor Power Switch.
5. Disconnect the adapter from the inflated item.
6. Unscrew and remove the adapter from the Sure Fit
®
nozzle.
7. Allow the unit to cool before storing away.
8. Store the compressor hose, nozzle and adapter in the storage compartment.
Recharge this unit fully after each use
WARNING –
To reduce the risk of injury or property damage: Follow
all safety instructions found in the "Specific Safety Instructions For
Compressors" section of this instruction manual.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, we recommend that the battery is
charged at least every 30 days.
From time to time wipe the outside of the appliance with a soft cloth. Do not
immerse the appliance in water.
There are no user-replaceable parts. Periodically inspect the condition of adapters,
connectors and wires. Contact manufacturer to replace any components that have
become worn or broken.
Battery
Please be advised that the battery is designed to last the service life of
the unit and is not replaceable, removable or serviceable. Service life is
dependent on a number of factors including but not limited to the number of
recharge cycles, and proper care and maintenance of the battery by the end user.
Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid
battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
TROUBLESHOOTING
Unit will not charge
• Make sure all of the unit's functions are turned off.
• Make sure a suitable gage extension cord is properly connected to both the unit
and a functioning AC outlet.
Unit Fails to Jump-Start
• Make sure unit's power switch is in the on position.
• Check that jump-starter has a full charge. Recharge unit if necessary.
• Make sure a proper polarity cable connection has been established.
6
USB Power Port will not power appliance
• Make sure the USB Charging Port Power Button is in the on position.
• Some USB-powered household electronics will not operate with this USB charging/
power port. Check the manual of the corresponding electronic device to confirm
that it can be used with this type of USB charging/power port.
• Check that jump-starter has a full charge. Recharge unit if necessary.
12 Volt DC Portable Power Supply will not power appliance
• Make sure the appliance does not draw more than 5 amps
• Check that jump-starter has a full charge. Recharge unit if necessary.
LED Area Light does not come on
• Make sure the LED Area Light ON/OFF button is in the on position
• Check that jump-starter has a full charge. Recharge unit if necessary.
Portable Compressor will not inflate
• Make sure the Compressor Power Switch is in the on position.
• Make sure the nozzle connector is securely screwed on to the valve stem when
attempting to inflate tires; or that the nozzle adapter is securely screwed into the
Sure Fit
®
nozzle connector and is inserted properly into the item to be inflated on
all other inflatables.
• The compressor may be overheated. Press the compressor power switch to turn the
compressor off. Restart after a cooling down period of approximately 30 minutes.
• Check that jump-starter has a full charge. Recharge unit if necessary.
ACCESSORIES
Recommended accessories for use with your tool may be available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at 1-877-571-2391.
The use of any accessory not recommended for use with this appliance could
be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the manufacturer at 1-877-571-2391.
FULL ONE-YEAR HOME USE WARRANTY
The manufacturer warrants this product against defects in materials and
workmanship for a period of ONE (1) YEAR from the date of retail purchase by the
original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the
defective product can be replaced or repaired in the following ways: (1) Return the
product to the manufacturer for repair or replacement at manufacturer's option.
Proof of purchase may be required by manufacturer. (2) Return the product to the
retailer where product was purchased for an exchange (provided that the store is a
participating retailer). Returns to retailer should be made within the time period of
the retailer's return policy for exchanges only (usually 30 to 90 days after the sale).
Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during shipping;
alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you
may have other rights which vary from state to state or province to province. This
product is not intended for commercial use.
Please visit our website www.baccusglobal.com/register to register your new Baccus
Global LLC product and to be kept up to date on new products and special offers.
SPECIFICATIONS
Boost Ampere:
12V DC, 1,000A peak battery, 500A
instantaneous, 5 seconds 300A
Battery Type:
Maintenance-free, sealed lead acid, 12V DC
Area Light:
1 long-life white LED
USB Port:
5V DC, 2.1A
DC Accessory Outlet:
12V DC, 5A
Compressor Maximum Pressure:
120 PSI
Sure Fit
®
is a registered trademark owned by Baccus Global LLC.
STANLEY
®
AND THE STANLEY
®
LOGO ARE REGISTERED
Imported by Baccus Global LLC,
TRADEMARKS OF STANLEY BLACK + DECKER INC.
621 NW 53rd St., Suite 450, Boca Raton, FL 33487
OR ONE OF ITS AFFILIATES, AND ARE
www.baccusglobal.com 1-877-571-2391
USED UNDER LICENSE.
RD072321
7
7/23/2021 12:01:44 PM
7/23/2021 12:01:44 PM
Advertisement
