3-3. Routing The Tubing - Panasonic U-72MF2U9 Installation Instructions Manual

3-3. Routing the Tubing

● The tubing can be routed out either from the front or from the bottom.
● The connecting valve is contained inside the unit. Therefore, remove the front panel.
(1) If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part indicated by
from the tubing cover.
(2) If the tubing is routed out from the bottom, remove the slit part (
● Use a drill bit approximately 13/64" (5.2 mm) dia. to create holes at the
5 slit hole indentations (openings).
● Punch out the slit part (
● Be careful not to damage the base plate.
Air intake
19/32 (15) 45-9/32 (1150)
(Installation hole pitch)
46-29/64 (1180)
A : 37-61/64 (964) [Installation hole pitch] * The tubing is routed out from the front.
B : 28-47/64 (730) [Installation hole pitch] * The tubing is routed out from the bottom.
C : 28-47/64 (730) [Installation hole pitch]
Front
Bottom
Remove 10 panel screws
from front panel
).
Unit: in. (mm)
ex.) type 72/96
Tubing cover
Use cutting pliers or similar
tool to cut cover out
Tubing cover
Slit hole
).
Tubing cover
Slit part
25
Remove 2 screws
Indentation (5 locations)
)