Changing To Two-Thread Serging - ELNA 664 PRO Instruction Manual

1
2
4
5
6
7
8
9

Changing to Two-thread Serging

Attach the 2 thread converter to the upper looper for
2-thread sewing.
* In case of two-thread serging, use one needle
To attach the 2 thread converter
Put the tip of the 2 thread converter into the hole on
the upper looper, and slide the 2 thread converter
down into the holder.
3
To remove the 2 thread converter
Pull tab on the holder toward you lightly. Push the
bottom of the 2 thread converter up and pull it out.
For standard two-thread serging, set the machine as
illustrated.
Standard two-thread serging is as illustrated.
10
34
thread and the lower looper thread. Remove
other threads.
1 2 thread converter
2 Upper looper
3
Holder
Tab
4
5 Lower looper pre-tension setting lever
(ST position)
6 Changeable thread guide (lower position)
7 Wrong side of fabric
8
Needle thread
9
Right side of fabric
Lower looper thread
10