Adjustment Of Cutting Width - ELNA 664 PRO Instruction Manual

1
(A)
(B)

Adjustment of Cutting Width

When cutting width is too narrow or too wide against
seam width, adjust it as follows.
Turn the cutting width adjusting dial to move the
lower knife to the desired position.
* The lower knife position can be set at 3–5 mm
from the right needle position.
1
2
3
4
Open the side cover to fully expose the cutting width
adjusting dial and deactivate the upper knife to more
easily turn the dial for wider stitch.
NOTE:
For general sewing, align the outer edge of the lower
2
knife with the guide line on the needle plate and the
indicator
4
3
Open the side cover to fully expose the cutting width
adjusting dial and deactivate the upper knife to more
easily turn the dial for wider stitch.
2
(A)
3
(B)
2
3
Test stitch to check the cutting width.
40
Cutting width adjusting dial
Lower knife
Guide line on the needle plate
is set at "N".
4
Indicator
When cutting width is too narrow.
Turn the cutting width adjusting dial clockwise.
Lower knife will move to right.
When cutting width is too wide.
Turn the cutting width adjusting dial
counterclockwise.
Lower knife will move to left.