Needle Position - ELNA 664 PRO Instruction Manual

w
q
r
e

Needle Position

The needles to be used for a specific stitch are
indicated by icons above the needle position marks.
Remove a needle if not to be used.
Tilting up the needle clamp
The needle clamp can be tilted up for easy needle
replacement and threading.
IMPORTANT:
When removing and inserting the needles, be sure
to:
– turn the power switch q off.
– turn the handwheel toward you and match the
alignment marks w.
– lower the presser foot.
Grasp the tab and pull the needle clamp up while
pushing the button.
e Tab
r Button
CAUTION:
Do not turn the handwheel while the needle clamp
is tilted up.
Removing the needle
Loosen the setscrew with the screwdriver.
Pull the needle down to remove.
Lightly tighten the setscrew to prevent it from
loosening during sewing.
Inserting the needle
Loosen the setscrew of the desired needle position.
Insert the needle with the flat side to the back.
Push the needle up as far as it will go and tighten
the setscrew securely.
Tilting down the needle clamp
Grasp the tab and push the needle clamp down
while pushing the button.
Release the button when the needle clamp is locked
in position.
Turn the handwheel slowly and check that the
needle(s) does not hit or thrust the presser foot or
needle plate.
30