Polaris Ranger RZR SW Service Manual page 242

FINAL DRIVE
4. Install rear wheel hub assembly, cone washers, and hand
tighten the castle nut. Install washers with domed side out.
Cone Washers
Wheel
Hub
5. Install brake caliper mounting bolts and torque to 18 ft. lbs.
(24 Nm).
Rear Caliper Mounting Bolts:
18 ft. lbs. (24 Nm)
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
7.26
Out
18 ft. lbs.
24 (Nm)
= T
CAUTION
6. Torque wheel hub nut to 80 ft. lbs. (108 Nm) and install a
NEW cotter pin. Tighten nut slightly if necessary to align
cotter pin holes.
80 ft. lbs.
(108 Nm)
Wheel Hub Castle Nut:
80 ft. lbs. (108 Nm)
7. Install wheel and (4) wheel nuts. Torque wheel nuts to
specification.
Wheel Nuts:
Steel Wheels: 35 ft. lbs. (47 Nm)
Aluminum Wheels: 30 ft. lbs. + 90° (1/4 turn)
8. Rotate wheel and check for smooth operation. Bend both
ends of cotter pin around end of spindle in different
directions.
NEW Cotter Pin
= T
= T