Polaris Ranger RZR SW Service Manual page 178

BODY / STEERING / SUSPENSION
The locking agent on the existing bolts was
destroyed during removal. DO NOT reuse old
hardware. Serious injury or death could result if
fasteners come loose during operation.
4. If not replacing the A-arm, thoroughly clean the a-arm and
pivot tubes.
5. Insert new A-arm bushings and pivot tubes into new A-arm.
Lower A-arm Removal
1. Remove the lower fastener (F) retaining the stabilizer bar
linkage to the lower A-arm.
F
2. Remove the fastener (G) retaining the lower portion of the
shock to the lower A-arm.
G
5.20
WARNING
J
H
3. Remove the fastener (H) attaching the lower A-arm to the
bearing carrier (see previous illustration).
4. Remove the (2) fasteners (J) attaching the lower A-arm to
the frame and remove the lower A-arm from the vehicle
(see previous illustration).
5. Examine A-arm and bearing carrier bushings and pivot
tubes (see "Exploded View"). Replace if worn. Discard
hardware.
6. If not replacing the A-arm, thoroughly clean the A-arm and
pivot tubes.
7. Insert new A-arm bushings and pivot tubes into new A-arm.