Prepare The Broiler For Use - Wells B-50 Supplemental Service Instructions

Electric charbroilers
Hide thumbs Also See for B-50:
Table of Contents

Advertisement

PREPARE THE CHAR-BROILER FOR USE
When using the broiler for the first
time, and after major repairs, wipe the
entire unit with a clean damp cloth or
sponge and mild detergent. Rinse
thoroughly clean water. Dry with a
soft clean cloth.
Remove the GRATE and raise the
ELEMENT ASSEMBLY.
Install the DRIP PAN and add
2" (5cm) of tap water.
Release the ELEMENT SUPPORT
ROD by lifting the element assembly
slightly, then pulling the lower portion
of the support rod forward. Gently
lower the ELEMENT ASSEMBLY.
MODEL B-40(6): Grate must be
installed ABOVE elements.
Install the GRATE, front edge first.
The TANGS of the grate go DOWN
and point toward the FRONT. The
grooves on the underside of the
grate align with the elements. The
rear edge of the grate can now be
lowered until it rests firmly on the
elements.
MODELS B-44(6) and B-50(6):
Grate(s) can be installed above or
below the elements.
ABOVE: Gently lower grate over
elements. The end with flush tabs
goes toward the front.
BELOW: Install one wing bolt in
each tab. The notch in the wing
rests on the lip of the drip pan. The
end with flush tabs must go toward
the front Adjust the wing bolts so
that , when the element assembly is
lowered, the top of the element is
1/4" (6mm) below the top of the
grate fins.
SERVICING INSTRUCTIONS (continued)
ELEMENT SUPPORT ROD
ELEMENT
HANDLE
FRONT
GRATE TANG
B-40(6) GRATE INSTALLATION
B-44(6) and B-50(6) GRATE INSTALLATION
5
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
IMPORTANT: DO NOT
attempt to raise the element
assembly without first
removing the grate. Damage
to the hinges will result. Such
damage is NOT covered by
warranty.
IMPORTANT: Allow drip pan
to cool before removing from
the broiler.
DO NOT operate the broiler
without the drip pan installed.
DO NOT operate the broiler
without 2" (5cm) of water in
the drip pan.
IMPORTANT: DO NOT
attempt to lower the element
assembly without first
releasing the support rod.
Damage to the hinges will
result. Such damage is NOT
covered by warranty.

Advertisement

Table of Contents
loading

This manual is also suitable for:

B-446B-406B-506B-44B-40

Table of Contents