Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
Seller’s obligation under this warranty is limited to the one year from the date of original installation or 18 months repair of defects without charge by a Wells Mfg. Co. factory from the date of shipment from our factory, whichever...
TABLE OF CONTENTS WARRANTY Thank you for purchasing this SPECIFICATIONS Wells Manufacturing Co. FEATURES & OPERATING CONTROLS appliance. PRECAUTIONS & GENERAL INFORMATION AGENCY LISTING INFORMATION Proper installation, professional INSTALLATION operation and consistent OPERATION maintenance of this appliance BROILER CHART will ensure that it gives you the...
FEATURES & OPERATING CONTROLS ITEM COMMENT TEMPERATURE CONTROL The char-broiler is INFINITE SWITCH CONTROLLED. Power is applied to the heating elements based on the control knob position and the amount of energy used. Light will glow when the infinite switch is in any position other that OFF. INDICATOR LIGHT HEATING ELEMENT The char-broiler element assembly may be raised for cleaning, or to...
Page 5
FEATURES & OPERATING CONTROLS (continued) Fig. 1 Built-In Electric Charbroiler Fig. 2 Wellsloks...
PRECAUTIONS AND GENERAL INFORMATION Broilers are intended for use to cook food products for human WARNING: consumption. No other use is recommended or authorized by the Electric Shock Hazard manufacturer or its agents. All servicing requiring access to non-insulated electrical Broilers are intended for use in commercial establishments, where all components must be users are familiar with the appliance limitations, use and associated...
INSTALLATION UNPACKING & INSPECTION NOTE: DO NOT discard the carton or other packing Carefully remove the appliance from the carton. Remove all protective materials until you have plastic film, packing materials and accessories from the appliance inspected the appliance for before connecting electrical power or otherwise performing any hidden damage and tested it installation procedure.
Page 8
INSTALLATION (continued) ELECTRCAL HOOK-UP WARNING: Risk of personal Refer to the nameplate. Verify the electrical service power. Voltage injury and phase must match the nameplate specifications. Connecting the Installation procedures must griddle to the wrong voltage can severely damage the unit or cause be performed by a qualified noticeable decreased performance.
Fig. 5 B-40 GRATE INSTALLATION Damage to the hinges will elements. result. Such damage is NOT covered by warranty. MODELS B-446 and B-506: Grate(s) can be installed above or below the elements. ABOVE: Gently lower grate over elements. The end with flush tabs goes toward the front.
Page 10
OPERATION (continued) CAUTION: TEMPERATURE CONTROLS Hot Surface Each section of the broiler is equipped with an individual temperature Exposed surfaces control. The desired temperature is controlled by rotating the can be hot to the touch and TEMPERATURE CONTROL KNOB. Any time the control is turned may cause burns.
OPERATION (continued) BROILER CHART RECOMMENDED COOKING TIMES AND DIAL SETTINGS NOTE: The times and dial settings in this chart are suggestions only. Your own experience with your own menu items will be your best guide to achieving the best food PRODUCT THICKNESS COOKING...
240V unit run on 208V Verify proper voltage Damaged component or wiring Contact an Authorize Wells Service Agency for repairs Temperature control not set Set temperature control knob to One or more section too desired temperature...
CLEANING INSTRUCTIONS PREPARATION CAUTION: Turn both temperature control knobs OFF. Electric Shock Allow broiler to cool completely. Hazard Disconnect broiler from electric power. Disconnect appliance from electric power before FREQUENCY cleaning. Daily. CAUTION: TOOLS Steel Brush with Scraper Burn Hazard Plastic Scouring pad, Soft-Bristled Fiber Brush Mild Detergent, Non-Abrasive Cleanser Allow appliance to cool...
PARTS & SERVICE DESCRIPTION SERVICE IMPORTANT: Use only PART NO. factory authorized GREASE PAN, B-446 (1 PER UNIT) service parts. B-506 (2 PER UNIT) 20174 For factory authorized service, or to order GREASE PAN, B-406 20202 factory authorized replacement parts,...