Panasonic DMC-FS20 Lumix Operating Instructions Manual page 131

[NOT ENOUGH SPACE ON BUILT-IN MEMORY]/[NOT ENOUGH MEMORY ON THE CARD]
• There is no space left on the built-in memory or the card.
–
When you copy pictures from the built-in memory to the card (batch copy), the pictures are copied
until the capacity of the card becomes full.
[SOME PICTURES CANNOT BE COPIED]/[COPY COULD NOT BE COMPLETED]
•
The following pictures cannot be copied.
–
When a picture with the same name as the picture to be copied exists in the copy destination.
(Only when copying from a card to the built-in memory.)
–
Files not based on the DCF standard.
•
Moreover, pictures recorded or edited by other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
•
This message will be displayed when you formatted the built-in memory on a PC.
> Format the built-in memory on the camera again.
deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
•
This card has a format which is not recognised by the camera.
> Format the card again with the camera after saving necessary data on a PC etc.
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]
•
This message appears when the camera is not operating properly.
> Turn the camera off and on. If the message persists, contact the dealer or your nearest Service
Centre.
[MEMORY CARD PARAMETER ERROR]
> Use a card compatible with this unit.
•
You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
•
An error has occurred accessing the card.
> Insert the card again.
[READ ERROR
PLEASE CHECK THE CARD]
•
An error has occurred reading the data.
> Insert the card again.
Others
(P33) The data on the built-in memory will be
(P20)
- 131 -
(P33)