Services; Pppoe Server - TP-Link TL-ER6120 User Manual

IP Address Pool

Pool Name:
IP Address Range:
List of IP Pool

In this table, you can view the information of IP Pools and edit them by the action buttons.
3.5.3.3 List of L2TP/PPTP Tunnel
This page displays the information and status of the tunnels.
Choose the menu VPN→L2TP/PPTP→List of L2TP/PPTP Tunnel to load the following page.
Figure 3-65 displays the connection status of the NO.1 entry in the list of tunnel in Figure 3-64. This
tunnel has been successfully established. Each tunnel has a Tunnel ID and a Session ID. The ID value
in client corresponds to that in server. The connection information of this tunnel in the server is shown
as the figure below.
Every time a tunnel connection is established, a tunnel ID and a session ID are created. In a router, the
ID values of different tunnels are different. A tunnel can create different ID values when it is
reconnected.

3.6 Services

3.6.1 PPPoE Server

The router can be configured as a PPPoE server to specify account and IP address to users in LAN and
thus you can control the dial-up of users for a high efficiency in network management.
Specify a unique name to the IP Address Pool for identification and
management purposes.
Specify the start and the end IP address for IP Pool. The start IP address
should not exceed the end address and the IP ranges must not overlap.
Figure 3-65 List of L2TP/PPTP Tunnel
-94-