Services; Pppoe Server - TP-Link SafeStream TL-ER6120 User Manual

IP Address Range:
List of IP Pool
In this table, you can view the information of IP Pools and edit them by the action buttons.
3.5.3.3 List of L2TP/PPTP Tunnel
This page displays the information and status of the tunnels.
Choose the menu VPN→L2TP/PPTP→List of L2TP/PPTP Tunnel to load the following page.
Figure 3-64 displays the connection status of the NO.1 entry in the list of tunnel in Figure 3-63. This
tunnel has been successfully established. Each tunnel has a Tunnel ID and a Session ID. The ID value
in client corresponds to that in server. The connection information of this tunnel in the server is shown
as the figure below.
Every time a tunnel connection is established, a tunnel ID and a session ID are created. In a Router,
the ID values of different tunnels are different. A tunnel can create different ID values when it is
reconnected.

3.6 Services

3.6.1 PPPoE Server

The Router can be configured as a PPP
thus you can control the dial-up of users for a high efficiency in network management.
The PPPoE configuration can be implemented on General, IP Address Pool, Account, Exceptional
IP and List of Account pages.
Specify the start and the end IP address for IP Pool. The
start IP address should not exceed the end address and
the IP ranges must not overlap.
Figure 3-64 List of L2TP/PPTP Tunnel
oE server to specify account and IP address to users in LAN and
-100-