Panasonic CF-48 Series Reference Manual page 31

PC Cards
Button
PC Card Utility Program
Removing a PC Card
CAUTION
Do not remove a PC Card while your computer is in the standby or
hibernation mode.
When two PC Cards are inserted, perform the following procedure
(from Step
Double-click
Card, then select [Stop].
Follow the on-screen instructions.
(When the PC Card has been removed after the computer is turned
off, this step is not necessary.)
Press the button out, then press the button again.
Slide the PC Card out.
Windows NT
About Phoenix Card Executive
When using a Windows NT
®
Windows NT is installed. When [Card Executive 2.0 for NT] is displayed in the
[Control Panel], this indicates that the program is installed.
If Phoenix Card Executive
®
disk or Windows NT Service Pack has been reinstalled, reinstall Phoenix Card
TM
Executive 2.0 for Windows NT
1
Select [Start] - [Run].
2
Input "c:\util\drivers\pccard\setup.exe", select [OK], then follow the on-screen in-
structions.
NOTE
Do not use the Control Panel Icon labeled [PC Card (PCMCIA)]. This Control
Panel will no longer function.
Instead, use the Control Panel Icon labeled [Card Executive 2.0 for NT] when
checking on the status of the PC Cards in your system.
to Step ) for each of the two cards.
( Windows 2000
TM 2.0 for Windows NT
®
model, confirm that Phoenix Card Executive™ 2.0 for
TM 2.0 for Windows NT ® has been uninstalled, or the hard
®
.
) on the taskbar, select the PC
®
31