Panasonic CF-48 Series Reference Manual page 27

CD Drive
Setting a Disc
Title-side up
Center Holder
Eject Button
Using the CD Drive in the MS-DOS mode
1
Turn your computer on
2
Press the disc eject button and slowly pull out the tray
3
Place the disc securely on the center holder
4
Close the tray
CAUTION
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
Power-saving Mode
If the CD drive has not been accessed within 90 seconds, the drive motor will automati-
cally shut down to reduce the power consumption. When the CD drive is accessed
once again, the power of the drive motor is turned on. However, approximately 30
seconds are required until data is actually read from the disc.
NOTE
If the vibration of the CD drive is excessive, set the [CD Drive Speed] to [Low] in the
Setup Utility.
1
Select [Start] - [Shut Down].
2
Select [Restart in MS-DOS mode], then select [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \ Enter
edit config.sys Enter
4
Move the cursor to the line containing "OAKCDROM.SYS", and delete the charac-
ters "rem" at the beginning of the line. (Deleting "rem" causes the item to become
valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS /D:MSCD000
(If this line is missing, add it.)
5
Press Alt + F , then S to save the file. Then press
to exit the Edit program.
6
Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat Enter
7
Move the cursor to the line containing "MSCDEX.EXE" and delete the characters
"rem" at the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8
Press Alt + F , then S to save the file. Then press
to exit the Edit program.
9
Restart the computer.
NOTE
Even if using the DVD-ROM drive or CD-R/RW drive, in the MS-DOS mode, only
CD-ROM disc are readable.
Windows 98
Alt + F , then X
Alt + F , then X
27