Table of Contents
Advertisement
www.freeservicemanuals.info
EN 8
4.
FTL2.4A AA
4.2
Service Position
For easy servicing of this set, there are a few possibilities
created:
•
The buffers from the packaging.
•
Foam bars (created for Service).
•
Aluminium service stands (created for Service).
4.2.1
Foam Bars
Figure 4-2 Foam bars
The foam bars (order code 3122 785 90580 for two pieces) can
be used for all types and sizes of Flat TVs. By laying the TV
face down on the (ESD protective) foam bars, a stable situation
is created to perform measurements and alignments.
By placing a mirror under the TV, you can monitor the screen.
4.2.2
Aluminium Stands
Figure 4-3 Aluminium stands (Mk1)
The new (Mk2) aluminium stands (order code 3122 785 90690)
can also be used to do measurements, alignments, and
duration tests. The stands can be (dis)mounted quick and easy
by means of sliding them in/out the "mushrooms".
Important: For (older) FTV sets without these "mushrooms", it
is obligatory to use the provided screws, otherwise it is possible
to damage the monitor inside!.
Mechanical Instructions
E_06532_018.eps
170504
E_06532_019.eps
170504
World of free manuals
4.3
Assy/PWB Removal
4.3.1
Metal Back Plate
Caution: Disconnect the mains power cord before you remove
the metal back plate.
1. Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution: do not put pressure on the display, but let the
monitor lean on the speakers or the Front cover.
2. Remove all T10 parker screws [1] from the top, left, and
right sides of the metal back plate.
3. Remove all T10 tapping screws [2] from the centre and
bottom of the metal back plate.
4. Lift the back plate from the TV. Make sure that wires and
flat foils are not damaged during the removal.
1 1
1
1
2
1
2
1
1
2
Figure 4-4 Metal back plate
4.3.2
Rear Cover
1. Disconnect all connectors [1] at both AmbiLight Inverters.
2. Remove all T10 parker screws [2] around the edges of the
rear cover.
3. Remove the four "mushrooms" [3] from the back plate.
4. Lift the rear cover from the TV.
2
2
2
2
3
2
1
2
2
2
2
2
Figure 4-5 Rear cover
4.3.3
LCD Supply Panel
1. Disconnect all cables from the LCD supply panel.
2. Remove all mounting screws from the LCD supply panel.
3. Take out the panel.
1
1
1
1 1
1
2
2
1
2
1
2
F_15490_011.eps
230605
2
2
2
2
3
2
2
2
2
2
F_15490_012.eps
17/6/2013
2
2
2
2
2
2
230605
Advertisement
Table of Contents
