Philips FTL2.4A Service Manual page 9

www.freeservicemanuals.info
4.3.4 AmbiLight Inverter Panel
These models are equipped with two AmbiLight Inverters
(however some early models can have only one inverter).
1. Disconnect all cables from the AmbiLight Inverter panel.
2. Remove all mounting screws [1] from the AmbiLight
Inverter panel.
3. Take out the panel.
Figure 4-6 AmbiLight inverter (left lower side)
1
1
Figure 4-7 AmbiLight inverter (right upper side)
4.3.5 Stand-by Supply/Audio Panel
1. Disconnect all cables from the Stand-by Supply/Audio
panel.
2. Remove all T10 mounting screws at the top of the Stand-
by Supply/Audio panel.
3. Take out the panel (it hinges at the bottom side).
4.3.6 Side I/O Panel
1. Disconnect the cable [1] from the Side I/O panel.
2. Remove the assy mounting screws [2].
3. Take out the assy.
4. Release the clamps [3] and take out the panel.
1 1
1
1
1
1
Mechanical Instructions
4.3.7
F_15490_014.eps
230605
F_15490_013.eps
230605
4.3.8
Figure 4-10 LED panel & speaker grid grounding wire
World of free manuals
FTL2.4A AA
3
2
Figure 4-8 Side I/O panel
Control Panel
1. Remove the glued foam block [1].
2. Remove the assy mounting screws [2].
3. Take out the assy.
4. Release the clamps and take out the panel.
2
Figure 4-9 Local keyboard
LED Panel
1. Disconnect all cables [2] from the LED panel.
2. Remove the mounting screws from the LED panel.
3. Take out the panel.
1
2
17/6/2013
4. EN 9
2
1
F_15490_024.eps
240605
1
F_15490_016.eps
240605
1
F_15490_025.eps
020805