Hy-022 Assembly; Hy-026/030 Assembly; Fan Assembly - Honeywell HY-026 Series Owner's Manual

HY-022-026-030_OM.qxd 10/13/06 2:07 PM
HY-022 SERIES ASSEMBLY INSTRUCTIONS
NOTE: Remove all contents from the box being careful not to discard the manual.
Remote Control Battery Installation/Replacement
• The remote control is located in the upper portion of the front
housing. Press on the remote control until you hear a "click"
sound to remove it from the recessed storage area in the fan
(Fig 1).
• Locate the tab on the side of the remote and gently squeeze the
tab and pull away from the remote (Fig 2).
• Remove the clear plastic protective sticker from the Lithium
CR2025 battery and place the battery back in the holder and
push the holder back into the remote. Make sure the (+ + ) side
is facing upward.
• To store the remote control, insert it back into the opening located
on the front of the fan. You will hear a "click", indicating the
remote is properly stored.
• The fan is now ready to be used.
Note: When replacing the battery, please follow the above
instructions.
Page 2
Fig. 1
Fig. 2
HY-026 SERIES/HY-030 SERIES ASSEMBLY INSTRUCTIONS
NOTE: Remove all contents from the box being careful not to discard the manual and hardware needed for
assembly.
A. Fan Assembly
• Align the rear and front base assembly and firmly snap together by
pushing the 4 round extrusions into the adjacent circles of the
connecting pieces (Fig 3).
• Use a phillips head screw driver ( ) to secure the rear and front
base assemblies together using the two (2) smaller 3mm screws
included with the fan (Fig. 4).
• Carefully turn the fan housing upside down.
• Place the base onto the fan housing making sure the three screw
holes located on the bottom of the fan line up with the holes on the
base (Fig 5).
• Locate the three (3) 5mm screws included with the fan and insert
them into the holes on the bottom of the base and tighten with a
phillips head screw driver ( ) (Fig. 6).
• Turn the fan right side up.
B. Remote Control Battery Installation/Replacement
• The remote control is located in the upper portion of the front
housing. Press on the remote control until you hear a "click"
sound to remove it from the recessed storage area in the fan
(Fig 7).
Fig. 5
• Locate the tab on the side
of the remote and gently
squeeze the tab and pull
away from the remote
(Fig 8).
• Remove the clear plastic
protective sticker from
the Lithium CR2025
battery and place the
battery back in the holder
and push the holder back
Fig. 7
into the remote. Make
sure the (+ + ) side is facing
upward.
• To store the remote control,
insert it back into the
opening located on the front
of the fan. You will hear a
"click", indicating the
remote is properly stored.
• The fan is now ready to be used.
Note: When replacing the battery, please follow the above instructions.
Fig. 3
Fig. 4
Fig. 6
Fig. 8