Assembly Instructions - Honeywell HFS-641PC Owner's Manual

ASSEMBLY INSTRUCTIONS

CLIPS
(G)
GRILLE
HUB
FRONT GRILLE
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the inside of
Base and push in (Fig. 1). Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE until it stops. DO NOT OVER-TIGHTEN.
ATTACHING THE CONTROL PANEL
• Assemble the Control Panel to the Metal Pole by lining up
the three (3) tabs of the Metal Pole with the three (3)
indented slots of the Control Panel. Push the pieces
together and rotate until they are secure (Fig. 4). Tighten
the knob on the back of the Control Panel to lock in
place.
• Insert the two (2) AAA batteries into the remote control
and slide it into the neck of the Control Panel.
COMPLETING THE ASSEMBLY
• Remove the Rear Grille Mounting Nut (D). Place the Rear
Grille (E) onto the Motor Housing by making sure the
three (3) holes of the Rear Grille fit over the three (3)
bumps on the Motor Housing. Tighten the Rear Grille
Mounting Nut CLOCKWISE (Fig. 3).
BLADE KNOB (F)
FAN BLADE
REAR GRILLE
REAR GRILLE (E)
MOUNTING
NUT (D)
REMOTE CONTROL
METAL
POLE (C)
BASE
MOTOR HOUSING
TIMER SPEED
2 4 8 L M
H
CONTROL
BREEZE
PANEL
TIMER
SPEED
OFF
BREEZE
SPEED
TIMER
OFF
Fig. 1
RECESSED
SLOT
Fig. 2
METAL
POLE
Fig. 3
D
C
2 4 8 L
M
H
CONTROL
PANEL
TAB
E