Section 4 - Operating Instructions; Controls And Instrument Identification - Scag Power Equipment SWZV36A-16KAI Operator's Manual

Section 4
CAUTION:
Do not attempt to operate this mower unless you
have read this manual. Learn the location and
purpose of all controls and instruments before you
operate this mower.
4.1 CONTROLS AND INSTRUMENT
IDENTIFICATION
Before operating the mower, familiarize yourself with all
mower and engine controls. Knowing the location,
function and operation of these controls is important for
safe and efficient operation of the mower.
1. Ignition Switch (Figure 4-1). The ignition switch is
used to start the engine. Manual start engines has two
positions; OFF and ON. Electric Start engines have
three positions; OFF, ON, and START.
ENGINE CHOKE
CONTROL
HOURMETER
IGNITION SWITCH
OPERATING INSTRUCTIONS
CUTTING HEIGHT
ADJUSTMENT
DECK LIFT
THROTTLE
CONTROL
MOWER DECK SWITCH
Figure 4-1 Controls
2. Mower Deck Switch (Figure 4-1). Used to engage
and disengage the mower drive system. Pulling up on
the switch will engage the deck drive. Pushing down
on the switch will disengage the deck drive.
3. Engine Choke Control (Figure 4-1). Used to start a
cold engine.
4. Engine Throttle Control (Figure 4-1). Used to
control the engine speed. Pushing the lever forward
increases engine speed. Pulling the lever back
decreases engine speed. Full back position is the
IDLE position. Full forward is the cutting position.
5. Hourmeter (Figure 4-1). Indicates the number of
hours the engine has been operated. It operates
whenever the engine is running. Has preset
maintenance reminders for engine and hydraulic
system oil changes. Will start flashing scheduled
maintenance 2 hours before preset time and continue
flashing until 2 hours after. Automatically resets.
ENGINE
11
SPEED
CONTROL
PARKING BRAKE
CONTROL
STEERING
CONTROL
SWZV CONTROLS