Table of Contents
Advertisement
R
CAUTION
Do not attempt to operate this mower unless you
have read this manual. Learn the location and
purpose of all controls and instruments before
you operate this mower.
4.1
CONTROLS AND INSTRUMENT
IDENTIFICATION
Before operating the mower, familiarize yourself with all
mower and engine controls. Knowing the location, function
and operation of these controls is important for safe and
efficient operation of the mower.
1.
Ignition Switch (Figure 4-1).
is used to start the engine and has three positions;
OFF, ON, and START.
PARKING BRAKE
WATER TEMPERATURE
MOWER DECK SWITCH
OIL PRESSURE
IGNITION SWITCH
VOLTMETER
FUEL SELECTION
SWITCH
OPERATING INSTRUCTIONS
The ignition switch
LEFT STEERING
CONTROL
CONTROL
ENGINE
THROTTLE
CONTROL
ENGINE
CHOKE
CONTROL
FUSES
DUMP VALVE
Figure 4-1.
Controls and Instruments
2.
Mower Deck Switch (Figure 4-1).
and disengage the mower drive system. Pulling up
on the switch will engage the deck drive. Pushing
down on the switch will disengage the deck drive.
3.
Engine Choke Control (Figure 4-1).
a cold engine.
4.
Engine Throttle Control (Figure 4-1).
control the engine speed. Pushing the lever forward
increases engine speed. Pulling the lever back
decreases engine speed. Full back position is the
IDLE position. Full forward is the cutting position.
5.
voltmeter (Figure 4-1).
the charging system. When the engine is running, in
normal operating conditions, the needle should be in
the 12 to 14 volt range.
DECK LIFT
12
Section 4
Used to engage
Used to start
Used to
Indicates the condition of
CUTTING HEIGHT
ADJUSTMENT
RIGHT STEERING
CONTROL
DECK RELEASE
SEAT BELT
FUEL GAUGE
HOURMETER
Advertisement
Table of Contents
