Defender 3.0 Voice Plus User Manual page 8

Figure10.5 Command Prompt
• From the command prompt in Windows, enter "nbtstat -R" to clear the Router previous
network cache. A message will show in command prompt – Successful purge and preload of
the NBT Remote Cache Name Table.
• To do that because, the Router probably assigned the DSA a new IP address, but the cache
name table s ll keeps the previous IP address (192.168.1.3).
• Open back the browser and log in back to DSA. Type in h p://defender:8088 and login page
will show (figure 3.0).
• Then access to network configura on web page, the lasted informa on for the IP address
was shown as below.
Monitor • Control
Figure 10.4
• Surveillance
To Ac vate The Remote Control
Press [*] [o] follow by [installer code] to access the system programming menu,
Press [33]
Light on the zone 7 and zone 8 LED,
Press [#] 2 me to save & exit programming menu.
To Reset Panel
Press [*] [o] follow by [installer code] to access the system programming menu,
Press [99]
Press [#] 2 me to save & exit the programming menu.
To Change The Sensi vity of zone Respond
Press [*] [o] follow by [installer code] to access the system programming menu,
press [45]
Enter the value [ ] [ ] [ ],
Example: High sensi ve [001], low sensi ve [255]
Press [#] to save & exit programming menu.
Changing Master Code
The system must be disarm,
Press [*] [6] follow by old master code [1234] (default)
Press [o]
Enter new master code for 2 me [xxxx] [xxxx] (4 digit)
Add User Code
The system must be disarm,
Press [*] [6] follow by [master code] (4 digit)
Press user number [x], maximum can set up to 8 user
Enter new user code for 2 me [xxxx] [xxxx] (4 digit)
To Add The Phone Number
The system must be disarm,
Press [*] [7] follow by [master code] (4 digit)
Press user number [x], maximum can set up to 4 user
Press the user phone number [
Press [#] a er finish, to save & exit Programming menu.
To Delete The Phone Number
Press [*] [7] follow by [master code] (4 digit)
Press user number [x], which want to delete
Press [#] to save & exit Programming menu.
To Turn On / Off The Chime Mode
The system must be disarm,
Press [*] [81]
Press [zone number] which want to on/off chrime mode.
Press [#] to save & exit programming menu.
26 7
]
Monitor • Control • Surveillance