Zone Programming - Defender 3.0 Voice Plus User Manual

b. PGM se ng (figure 6.0)
• Timer Arm/Disarm – set the auto mer arm or disarm the par
hour format).
• Timer PGM – set the auto mer on or off light (24 hour format). If PGM are not 64, 65, and 66, cannot
auto mer func on. Refer to installer manual for PGM defini on.
ARM
Partition 1
ARM
Partition 2
24 Hr Format Light 1
Timer 1
On
Off
Timer 2
On
Off
Figure 6.0 PGM Se ng
c. Network se ng (figure 7.0)
• For Dynamic DHCP, ck the Enable DHCP.
• For Sta c, un- ck the Enable DHCP (refer to step 4.0 for detail).
This page allows the configuration of the board's network settings.
CAUTION: Incorrect settings may cause the board to lose network connectivity. Recovery
options will be provided on the next page.
Enter the new settings for the board below:
Figure 6.0 PGM Se ng
Monitor • Control
on 1 or par on 2 alarm panel (24
DISARM ENABLE
DISARM ENABLE
Light 2 Note
To use the auto
mer please
perform PGM
se ng
• Surveillance
REMOTE CONTROL CONNECTION LAYOUT
KEYPAD CONNECTION (1) LAYOUT KEYPAD CONNECTION (2) LAYOUT

ZONE PROGRAMMING

Zone Type
Delay
Internal
Instant
24 Hour
Fire
Silent
Zone Respond
Intelligent Zone 1
Intelligent Zone 2
Zone Par
Zone Par
Auto Reset Zone
Par on 1 user
Par on 2 user
22 11
+V & -V - connect to Dc 12 power supply.
1 S - Connect 1 S to zone 8
2 S - Connect 2 S to pin number 2
Com - Connect com to pin number 1
(1 S is use for panic bu on)
(2 S is use for Arm and Disarm System)
connect to
zone 8
Address
Default Zone Type
1 2 3 4
Zone
10
11
13
14
15
16
18
19
20
on1 21
on2 22
23
25
26
Monitor • Control • Surveillance
Connect the 8G with Dt
Connect the SCK with CIK
Connect the Gnd with Gnd
Connect the 12V with 12V
5 6 7 8
( is default se ng)