Table of Contents
Advertisement
12 – Maintenance and settings–User setups in RAM
12.4
User setups in RAM
Commonly-used setups are saved in one of three user
setup memory banks: 1, 2 or 3. This enables pre-con-
figuration of the DA-98HR for different jobs (video
or film post-production, or different recording setups,
for example). There is also a preset memory bank
which contains the factory settings (see below).
When the DA-98HR is shipped, the contents of all
setup memories are the same; they contain the fac-
tory settings.
12.4.1 Saving user setups
1 Go to menu group 9, move the cursor to
Setup
and press
ENTER
S e t u p
L o a d
1
2 To save the current setup, press the § key
while the word
Load
bottom line now reads
S e t u p
S a v e
1
3 Move the cursor (Ó and Á keys) to
, and press the § key:
3
S e t u p
A r e
y o u
S a v e
1
4 To save the current setup to the selected setup
memory, press the
ENTER
Complete
The word
screen for about 2 seconds and the user settings
are saved to the selected setup memory bank.
:
2
3
F
is flashing so that the
Save
:
2
3
1
2
,
or
s u r e ?
3
2
key.
appears on the
12.4.2 Loading user setups
1 Go to menu group 9, move the cursor to
Setup
and press
ENTER
S e t u p
L o a d
1
2 To load the setup memory into the current
memory, make sure the bottom line shows
Load
:
S e t u p
L o a d
1
3 Move the cursor to
1
key:
S e t u p
A r e
y o u
1
L o a d
4 Press
. The word
ENTER
appears on the screen for about 2 seconds. The
contents of the currently-selected setup are
loaded into memory and the unit resets itself.
NOTE
Since the unit resets when a user memory is loaded, you
should make sure that the levels of all monitoring equip-
ment, etc. are turned down, to avoid "thumps" and possible
damage to ears and equipment.
12.4.3 Resetting the memory to factory
defaults
You may sometimes want to reset all of the memory
to factory settings. The values of all the factory set-
tings are listed in 11, "Menu and parameter refer-
ence".
1 Follow the instructions regarding loading user
F
setups, but choose
2 Press
. The word
ENTER
appears on the screen for about 2 seconds. The
factory settings are loaded into memory and
the unit resets itself.
:
2
3
F
2
3
F
, and press the §
2
3
,
or
s u r e ?
2
3
F
Complete
as the memory to load.
Complete
85
TASCAM DA-98HR
Advertisement
Table of Contents
