Alpha Communications VM25WH Series Installation And Use Instructions Manual page 6

TYPICAL WIRING DIAGRAM FOR SINGLE ENTRANCE SYSTEM
WITH S.T.R.™ STYLE CAMERA AND ONE (1) VIDEO RISER
(NO VIDEO DISTRIBUTORS) AND 1-4 MONITORS
Notes:
All Model HT2006/5 (5-button)
Master Handsets shown. You may
also use HT2006/10 (10-button)
Master Handsets which basically wire
the same as the 5-button handsets,
except they also have terminals
'6' thru '10' as well as '1' thru '5'.
Terminals '1' thru '5' (on the HT2006/5)
and terminals '1' thru '10' (on the
HT2006/10) are the calling out
terminals and terminal 'Z' is the terminal
that determines the handset number
that is called.
This configuration shows a 1-button
door entry station that signals all four (4)
HT2006 handsets simultaneously. You
may use a multi-button door entry station,
by connecting the selective button wire(s)
to terminal 'R' on the corresponding HT2006
handset(s) being called by that button.
Each handset that is called by a door station
must have the model R2006 Alphatone™
signaling module installed (see page 4).
The Electric Door Opener shown in this
illustration is activated by depressing button
#5 on each of the HT2006 handsets. Each
HT2006 handset comes with a separate
plastic 'KEY SYMBOL' button that may
be substituted for the numbered door
release button used (if desired).
Notes:
1. All wiring is #22AWG unless shown otherwise.
2. When using a PINHOLE type camera, instead of the standard S.T.R.™ type camera, see the special camera
installation and connection instructions found on page 9, and do not power as shown above.
3. The most recent NH208TVU has two (2) 'O' and '8V' terminals. They are duplicated for ease of wiring. You
may use either or both. Both sets are internally connected together inside the NH208TVU on the p.c. board.
4. DO NOT CONNECT MORE THAN 10 MONITORS PER VIDEO RISER/LINE.
5. Observe all local and national electrical and building codes.
6. All terminals connections shown may not be in the order that they appear on the equipment.
6