Maintenance - Horizon Fitness TREADMILL 202 Owner's Manual

6. Maintenance

1. If the Walking Belt tracks off center to the right or
left of the deck, first turn the power off. Then use a
6mm wrench (f) to tighten the rear roller bolt on the
side of the treadmill toward which the belt is moving.
For example, if the belt moves to the left and the
deck becomes exposed on the right, tighten the bolt
on the left side of the frame. Tighten about 1/4 of
turn (clockwise). If the belt does not move back to
the center of the treadmill, make another adjustment
to the same bolt. Once the Walking Belt has been
adjusted closer to the center, the treadmill can be
started again.
(Ps.1.This action is very important, please follow
the above steps.)
(Ps.2. The potion of running belt might not stay precisely in
the center with slightly moving the left or right side, and
the situation varies with how end-users use and weight
of end-users. When end-user use properly, the belt won't
scotch side rails. )
2. It is strongly suggested to follow the Table (in below) to
apply lubrication on running deck. Please use 6mm
wrench to loosen bolts in rear adjusting boxes. Pull up
the running belt and apply lubrication evenly on the
center of the running deck, then adjust the belt to the
center of deck, follow by tighten the screw to the
original set up.
(Ps. When the belt is sliding, please follow the adjusted
method.)
Speed
1~6 km/h
6~12km/h
12km/h 以上
Interval
1 year
6 months
3 months