Exterior; Interior - Carver 360 SPORT SEDAN Owner's Manual

W
INTERIZATION AND
Open Closed
10. Close the overboard discharge seacock.
11. Switch the Grey Water Pump circuit breaker "OFF."
12. When you remove your boat from storage and prepare to use it again,

8.3.9 Exterior

Wash the exterior of the boat, particularly the underwater portions.
Remove as much aquatic growth as possible while it is still wet. Once the
growth has dried it is more difficult to remove.
Check the zinc sacrificial anodes for deterioration. If the zincs show signs
of deterioration have them replaced before spring launch. Check stain-
less steel rails and fittings for signs of rust. Remove rust prior to winter
lay-up. Inspect the underwater portions of the hull. Review anything that
looks out of the ordinary with your Carver Dealer.

8.3.10 Interior

Air out the cushions and make sure they are dry. Storing damp cushions
leads to mildew. Position the cushions so air can circulate around them.
Purchase and position moisture accumulators throughout the boat. These
help reduce the amount of moisture that accumulates during storage.
Remove everything from the boat that could spoil or freeze while the
boat is stored. Also remove all dried food. Food attracts mice and insects.
To give your boat the maximum protection while it is in storage, Carver
recommends that you place your boat in dry, as opposed to wet, storage.
Protecting the boat from the elements during winter storage is advised.
Have your marina shrink wrap the boat or have a winter storage cover
made. Occasionally check on the boat while it is in storage to make sure
that it is in good condition.
S
TORAGE
5. Under the boat, place a large bucket beneath the grey water over-
board discharge fitting to collect antifreeze pumped out later in this
procedure.
6. Open the grey water overboard discharge seacock.
7. On the DC Control Center, switch the DC Main circuit breaker
"ON," then switch the Grey Water Pump circuit breaker "ON."
8. Turn the grey water pump switch "ON."
9. When a steady stream of antifreeze flows from the grey water over-
board discharge fitting, turn the grey water pump switch "OFF."
flush and pump out the grey water tank to remove the antifreeze.
S 8
ECTION
3428 5/03