Starting a Video Conference
•
When a contact in the incoming call history is
newly added to your contact list, the incoming call
history will be updated to display the contact's
information from the contact list.
•
When a party that is not registered in your contact
list is selected, if you press [B], the contact list
registration screen will be displayed and a new
contact can be registered (Page 95). Also, you
may not be able to register a SIP URI (or SIP user
name), H.323 extension, or H.323 name from the
incoming call history to the contact list for
reasons such as non-compliance with the
relevant standards. In this case, contact your
network administrator.
3
Select the party you want to call using [
Note
•
If you press [Enter], the call history details
screen is displayed.
•
When not selecting a local site (Page 135),
"Local site name" will be blank.
•
The lowest bandwidth for the maximum
bandwidth setting among all participating parties
is displayed in "Bandwidth". If the video
conference call was not established, the
maximum bandwidth will be blank.
•
Depending on the other party, "Device type"
may be blank.
•
If you press [G], the input screen is displayed,
and you can edit the address before calling.
4
Press [Start].
•
The input screen is displayed.
Note
•
You can change the number of sites called
or edit the other party's address.
5
Press [Start] to start the call.
6
When you want to end the call, press [End].
•
The Home screen is displayed.
50
User Manual
][
].
Document Version 2013-09