Getting Started - Kenwood KMM-U21 Instruction Manual

GETTING STARTED

1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [CLOCK], then press the knob.
3
Turn the volume knob to select [CLOCK ADJUST], then press the
knob.
4
Turn the volume knob to make the settings, then press the knob.
Day Hour Minute
5
Turn the volume knob to select [CLOCK FORMAT], then press the
knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
7
Press and hold to exit.
To return to the previous setting item, press
While in clock display screen...
Press and hold to enter clock adjustment mode directly.
4
Then, perform step to set the clock.
4
3
1
Press
2
Press the volume knob to enter [FUNCTION].
For
3
Turn the volume knob to make a selection (see the following table),
then press the knob.
4
Repeat step
5 Press and hold
To return to the previous setting item, press
AUDIO CONTROL
SWITCH
PREOUT
SP SELECT
TUNER SETTING
PRESET TYPE
SYSTEM
KEY BEEP
TDF ALARM
.
SOURCE SELECT
PANDORA SRC (For
BUILT-IN AUX
Set the initial settings
repeatedly to enter STANDBY.
: Pressing AUD enters [AUDIO CONTROL] directly.
3
until the desired item is selected or activated.
to exit.
REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected
to the line out terminals on the rear (through an external amplifier).
OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches
or 4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum
performance.
NORMAL: Memorizes one station for each preset button in each band
( 5). ; MIX: Memorizes one station for each preset button, regardless of
the selected band.
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Activates the alarm if you forget to detach the faceplate when ACC is
set to OFF. ; OFF: Deactivates.
)
ON: Enables PANDORA in source selection. ; OFF: Disables. ( 9)
ON: Enables AUX in source selection. ; OFF: Disables. ( 10)
.
Default: XX