Getting Started; Select The Display Language And Cancel The Demonstration - Kenwood DPX505BT Instruction Manual

Basics
Remote control (RC-406)
This unit can be remotely controlled with an optionally purchased remote
control.
Remote sensor
(Do not expose to bright sunlight.)
How to replace the battery
To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
Pull out the insulation sheet when
using for the first time.
or VOL .
to continuously increase

Getting Started

1

Select the display language and cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1 Turn the volume knob to select [ENG] (English) / [SPA] (Spanish) /
[FRE] (French), then press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB".
2
Press the volume knob again.
[YES] is selected for the initial setup.
3
Press the volume knob again.
"DEMO OFF" appears.
5
ENGLISH