NEPTUNE 2 Contents Symbols used to mark ....................4 instructions 1 Important safety ....................4 instructions Purpose ................6 2 Description Operating elements ..............7 Setting up the cleaner ............7 3 Before starting the cleaner Before use ................7 Fill up detergent tank ............7 Fill up fuel tank ..............8 Connecting the high pressure hose........8...
NEPTUNE 2 Safety instructions This indicates Symbols used to mark in these operating tips and instruc- instructions instructions which tions to sim- must be observed plify work and to prevent risks to ensure safe to persons are marked with this operation.
Page 5
NEPTUNE 2 If the mains power lead is dam- Do not clean delicate parts ployed outside the hazard areas aged, to avoid hazards, this made of rubber, fabric, etc. with defined in the German „Techni- must be replaced either by the the 0°...
Strasse 449, 50939 Cologne or cian. duce aerosols production, from the appropriate associa- Please contact the Gerni service e.g., a shield covering the tion of employers’ liability insur- department or an authorised nozzle.
Ker- el, your burner may require re- osene or Diesel. adjustment for proper perfor- Your Gerni hot water pressure mance and best fuel economy. washer was thoroughly tested Contact your Dealer or Gerni and adjusted for optimum per- for assistance.
NEPTUNE 2 With the machine cold: Fill up fuel tank Fill fuel tank from a clean con- NOTE! tainer with a fresh fuel, heating At temperatures below 8° C, the fuel oil begins to solidify (paraffin precip- oil, DIN 51603-1 (without bio itation).
NEPTUNE 2 CAUTION! Electrical connection When using cable reels: 1. Due to the risk of overheat- 400V 400V ing and fire, always unwind the power supply cord fully. The cleaner may only be con- nected to a correctly installed electrical installation.
NEPTUNE 2 4 Control / Operation 1. Move the main switch into Switching on the position 'Cold Water' (A) cleaner The control electronics sys- tem performs a self-test, all the LEDs light up once. The motor starts lights up. Always remove any dirt from the 2.
NEPTUNE 2 1. Replace the standard nozzle 4.2.3 Steam operation (over with the steam spray nozzle 100°C) (See catalogue for accesso- ries). 2. Open cover. 3. Turn the twist grip on the safety control block com ple- te ly to the left (anti clock wise direction).
NEPTUNE 2 5 Applications and methods Effi cient high pressure cleaning is achieved by following a few Techniques guidelines, combined with your own personal experience of specifi c cleaning tasks. Accessories and detergents, when correctly chosen, can increase the effi ciency of your pressure washer. Here is some basic information about cleaning.
Page 13
These are merely several examples of cleaning tasks that can be solved by a pressure washer in asso- ciation with accessories and detergents. Each cleaning task is different. Please consult your local dealer or Gerni representative in order to discuss the best solution for your own cleaning tasks. Options / model variants...
NEPTUNE 2 6 After using the cleaner 1. Close water tap Switching off 2. Activate spray gun without the cleaner and lance in order to empty all re- disconnecting supply sidual water in the system lines 3. Turn the main switch to posi- tion „OFF“.
NEPTUNE 2 7 Maintenance Maintain water filters and fuel fil- Maintenance plan ters as required. A water fi lter is fi tted on the water Maintenance work inlet to prevent large particles of 7.2.1 Water filters dirt from entering into the pump.
NEPTUNE 2 8 Troubleshooting Indications on Display Indication lights Cause Remedy > The light is constant > Refuel detergent or set SDR - The appliance is ready for value to “0“ operation > Flashing light - Flow sensor fault - Water tap closed or water...
NEPTUNE 2 Indication lights Cause Remedy > Flashing light > Turn main switch to position - Motor is overheated “OFF“ - let the machine cool down Remove/disconnect extension cable Possible phase failure on 3 phase variants: have electrical connection checked >...
NEPTUNE 2 9 Further information If the cleaner is discarded, make The cleaner contains valuable Recycling the cleaner it unusable immediately materials that should be recy- cled. Therefore, make use of 1. Unplug the cleaner and cut your local waste disposal site.
NEPTUNE 2 EU Declaration of Conformity EU Declaration of Conformity High Pressure Washer Product: NEPTUNE 2 Type: EC Machine Directive 2006/42/EC The design of the unit corre sponds to EC Low-voltage Directive 2006/95/EC the following pertinent regulations: EC EMC Directive...
Page 20
AUSTRALIA: Nilfi sk-Advance Pty LTd Unit 1/13 Bessemer Street Blacktown NSW 2148 Phone: 1300 556 710 E-mail: sales@gerni.com.au...
Need help?
Do you have a question about the NEPTUNE 2 and is the answer not in the manual?
Questions and answers