Left Oven Bake Burner And Igniter Removal (Vgsc548 Series); Bake Burner Igniter Removal; Bake Burner Removal - Viking VGSC530 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
4. Remove screws and bracket that secure inner glass
panel.
5. Lift inner glass from inner glass panel.
6. Remove black fi berglass rope from inner glass panel.
Note: Use care with insulation; make sure to replace
any damaged or missing insulation.
7. Reverse procedure for installation.
Left Oven Bake Burner and Igniter Removal
(VGSC548 Series)
Condition Requirements:
Left Oven Door Assembly Removed
1. Lift to remove oven cavity bottom panel from range.
2. Remove screw and burner from range.
3. Disconnect wire from igniter.
4. Remove screw and igniter from burner.
5. Reverse procedure for installation.
28

Bake Burner Igniter Removal

Condition Requirements:
Door Assembly Removed
1. Remove two screws and lift kick plate from keyhole
screws.
2. Lift to remove oven cavity bottom panel from range.
3. Disconnect wire from igniter.
4. Remove screw and igniter from bake burner.
5. Reverse procedure for installation.

Bake Burner Removal

Condition Requirements:
Bake Burner Igniter Removed
1. Loosen two screws that secure bake burner in rear of
cavity.
2. Remove two screws and bake burner from range.
3. Reverse procedure for installation.
©2010 Viking Preferred Service