Table of Contents
Advertisement
Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Door Hinge Removal
Condition Requirements:
Outer Door Panel Assembly Removed
1. Place the inner door panel assembly on a protected
surface.
2. Remove screws, nut, and hinge from inner door
panel.
3. Reverse procedure for installation.
Bake Burner Igniter Removal
Condition Requirements:
Door Assembly Removed
1. Remove screws and lift kick plate from keyhole
screws.
2. Lift to remove oven cavity bottom panel from range.
3. Disconnect wire from igniter.
4. Remove screw and igniter from bake burner.
5. Reverse procedure for installation.
20
Bake Burner Removal
Condition Requirements:
Bake Burner Igniter Removed
1. Remove screws and bake burner from range.
2. Reverse procedure for installation.
Bake Burner Orifice Removal
Condition Requirements:
Bake Burner Removed
Note: Before removing orifice, secure gas tubing to
avoid bending or twisting of gas tubing.
1. Remove orifice from manifold.
2. Reverse procedure for installation.
Broil Burner Igniter Removal
Condition Requirements:
Door Assembly Removed
1. Remove two screws and pull igniter wire into oven
cavity.
2. Disconnect wire to remove igniter from range.
(View of top of oven cavity)
3. Reverse procedure for installation.
©2010 Viking Preferred Service
Advertisement
Table of Contents
