Gas Solenoid Valve Removal; Pressure Regulator Removal - Viking VGSC530 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Gas Solenoid Valve Removal

Condition Requirements:
Main Top Removed
Gas Supply Disconnected
Note: Gas solenoid valve may be accessible without
removing main top on some 36" and 48" models
equipped with a surface grill.
Note: Some solenoid valves may be protected by a
heat shield. Remove to access solenoid.
Gas leak hazard. To avoid risk of personal injury
or death, leak testing of the appliance must
be conducted according to the manufacturer's
instructions. Before placing appliance in operation,
always check for gas leaks with soapy water solution.
DO NOT USE AN OPEN FLAME TO CHECK FOR
GAS LEAKS.
1. Remove screw and position jet holder bracket out of
way.
2. Mark and disconnect two wires from solenoid coil.
3. Remove two gas tubes from solenoid valve.
4. Remove two screws and solenoid valve from range.
5. Reverse procedure for installation.
6. Perform gas leak test.
©2010 Viking Preferred Service

Pressure Regulator Removal

Condition Requirements:
Island Trim or Backguard Assembly Removed
Gas Supply Disconnected
Gas leak hazard. To avoid risk of personal injury
or death, leak testing of the appliance must
be conducted according to the manufacturer's
instructions. Before placing appliance in operation,
always check for gas leaks with soapy water solution.
DO NOT USE AN OPEN FLAME TO CHECK FOR
GAS LEAKS.
1. Remove screw and cover from range.
2. Remove pressure regulator from manifold.
3. Reverse procedure for installation.
Note: Use approved sealant when installing pressure
regulator.
4. Perform gas leak test.
Disassembly
39