Table of Contents
Advertisement
Connecting Other Equipment
Connecting other
equipment to the TV
*Smartlink is a direct link between the TV and a
compatible VCR or DVD recorder. Ensure that
your VCR/DVD recorder is connected to the
scart socket labelled i2/r, using a fully wired
21 pin scart lead. For more information on
Smartlink, refer to the instruction manual
supplied with your Smartlink VCR/DVD recorder.
Viewing pictures from
a connected VCR
Viewing pictures from
equipment connected
to the rear sockets
Viewing pictures from
equipment connected
to the front sockets
28
Connecting Other Equipment
A wide range of equipment can be connected to the TV through the front and rear
sockets. Most equipment can be connected to any of the TV sockets. Refer to the
instruction manual supplied with your equipment to determine the best TV socket
to use. This TV supports the following inputs:
TV Sockets
Socket type(s)
i1/
Scart
i2/r
Scart
o3 and
3
Phono (x2),
r
4 pin DIN
o3 and t3
Phono (x3)
If you have used a fully wired 21-pin scart lead to connect the VCR:
Refer to 'Viewing pictures from equipment connected to the rear sockets', below.
If you have not used a fully wired 21-pin scart lead to connect the VCR:
You will need to find the video channel:
1.
Insert a pre-recorded tape into the VCR and press the 'PLAY' button.
2.
If you inserted a pre-recorded tape and pressed 'PLAY' during the
autotune process, as instructed on page 6:
With the TV in analogue mode, press the PROG +/- buttons until the
picture from the pre-recorded tape is displayed on the TV screen.
In future, with the TV in analogue mode, press the Numbered buttons to
directly select the video channel.
If you wish to move your video channel, refer to the 'Programme Sorting'
on page 23.
If you did not insert a pre-recorded tape and press 'PLAY' during the
autotune process, as instructed on page 6:
You will need to manually tune in the VCR signal (ideally to channel 0).
Insert a pre-recorded tape into the VCR and press the 'PLAY' button.
Refer to the 'Manual Programme Preset menu' section of this instruction
manual to manually tune in the VCR signal.
After manually tuning the VCR signal and with the TV in analogue mode,
press the Numbered buttons to directly select the video channel.
1.
Switch on/press 'PLAY' on the connected equipment. The picture (if any)
from the equipment appears on the TV screen.
If the picture does not automatically appear press the
repeatedly until the picture is displayed on the TV screen.
2.
Press the DIGITAL/a button to return to normal TV operation.
1.
button repeatedly until the t3 symbol appears on the
Press the
/
TV screen.
2.
Switch on/press 'PLAY' on the connected equipment. The picture (if any)
from the equipment appears on the TV screen.
3.
Press the DIGITAL/a button to return to normal TV operation.
Inputs supported
RGB, Audio/Video.
S-Video, Audio/Video, Smartlink*.
Audio/S-Video.
(audio via o3 sockets, S-Video via
Audio/Video.
(audio via o3 sockets, video via t3 socket)
3 socket)
r
/
button
Hide quick links:
Advertisement
Table of Contents
