Connecting Other Equipment To The Tv; Viewing Pictures From A Connected Vcr; Viewing Pictures From Equipment Connected To The Rear Sockets; Viewing Pictures From Equipment Connected To The Front Sockets - Sony KD-28DL11U Operating Instructions Manual

Connecting other
equipment to the TV
z
*Smartlink is a direct link between the TV
and a compatible VCR or DVD
Recorder. Ensure that your VCR/DVD
recorder is connected to the scart socket
labelled i2/r, using a fully wired 21
pin scart lead. For more information on
Smartlink, refer to the instruction manual
supplied with your Smartlink VCR/DVD
recorder.
**Only for KD-28DX51U / KD-32DX51U
models.
Viewing pictures from
a connected VCR
Viewing pictures from
equipment connected
to the rear sockets
Viewing pictures from
equipment connected
to the front sockets
A wide range of equipment can be connected to the TV through the front and rear
sockets. Most equipment can be connected to any of the TV sockets. Refer to the
instruction manual supplied with your equipment to determine the best TV socket
to use. This TV supports the following inputs:
TV Sockets Socket type(s)
i1/ Scart
i2/r Scart
o3 and Phono (x2),
3** 4 pin DIN
r
o3 and t3 Phono (x3)
If you have used a fully wired 21-pin scart lead to connect the VCR:
Refer to 'Viewing pictures from equipment connected to the rear sockets', below.
If you have not used a fully wired 21-pin scart lead to connect the VCR:
You will need to find the video channel:
1.
Insert a pre-recorded tape into the VCR and press the 'PLAY' button.
2.
If you inserted a pre-recorded tape and pressed 'PLAY' during the
autotune process, as instructed on page 7:
With the TV in analogue mode, press the PROG +/- buttons until the
picture from the pre-recorded tape is displayed on the TV screen.
In future, with the TV in analogue mode, press the Numbered buttons to
directly select the video channel.
If you wish to move your video channel, refer to the 'Programme Sorting'
on page 24.
If you did not insert a pre-recorded tape and press 'PLAY' during the
autotune process, as instructed on page 7:
You will need to manually tune in the VCR signal (ideally to analogue
channel 0).
Insert a pre-recorded tape into the VCR and press the 'PLAY' button.
Refer to the 'Manual Programme Preset menu' section of this instruction
manual to manually tune in the VCR signal.
After manually tuning the VCR signal and with the TV in analogue mode,
press the Numbered buttons to directly select the video channel.
1.
Switch on/press 'PLAY' on the connected equipment. The picture (if any)
from the equipment appears on the TV screen.
If the picture does not automatically appear press the
repeatedly until the picture is displayed on the TV screen.
2. Press the DIGITAL or a button to return to normal TV operation.
1.
Press the / button repeatedly until the t3 symbol appears on the
TV screen.
2. Switch on/press 'PLAY' on the connected equipment. The picture (if any)
from the equipment appears on the TV screen.
3. Press the DIGITAL or a button to return to normal TV operation.
Connecting Other Equipment
Inputs supported
RGB, Audio/Video.
S-Video, Audio/Video, Smartlink*.
Audio/S-Video.
(audio via o3 sockets, S-Video via
Audio/Video.
(audio via o3 sockets, video via t3 socket)
Connecting Other Equipment
3 socket)
r
/ button
33