Connecting An Aerial And Vcr; Switching On The Tv - Sony KD-28DX50 U Manual

3

Connecting an aerial and VCR

Rear of TV.
Scart lead
(not supplied)
Rear of TV.
4

Switching on the TV

Supplied RF lead
Supplied
RF lead
On/Off button
1. Connect your aerial lead to the socket labelled
on the rear of the TV.
2.
Connect the supplied RF lead from the socket
labelled on the rear of the TV to the socket
labelled IN* on your VCR.
3. Connect an RF lead from the socket labelled OUT*
on your VCR to the socket labelled
of the TV.
4. Connect a fully wired 21-pin scart lead from the
socket labelled i2/r on the rear of the TV to the
socket labelled TV* on your VCR**
5.
Insert a pre-recorded tape into the VCR and press
the 'PLAY' button. This enables the TV to locate
and store the
'Automatically tuning the TV' procedure.
z
*Socket names may vary depending on make and model
of VCR. Refer to your VCR instruction manual for details.
**If your VCR does not have a scart socket follow the
connecting instructions above ignoring the scart lead
connection.
Connecting an aerial only
1. Connect your aerial lead to the socket labelled
on the rear of the TV.
2. Connect the supplied RF lead from the sockets
labelled and
1. Connect the TV plug to your mains socket
(220 - 240V AV, 50Hz)
2. Push in the On/Off button (labelled !) on the front
of the TV.
z
If the red standby mode indicator on the front of the TV is
lit, press the TV I/1 button on the remote control to switch
on the set. Please be patient as the picture may take a
few moments to appear on the TV screen.
Basic Operation
2 on the rear
video channel during
2 on the rear of the TV.
Basic Operation
1
the
1
5