Setting The Time And Using The Timer - Samsung T24D390SW User Manual

Advanced Features
Setting the Current Time
→ →
System Time Clock
Set the clock manually or automatically. Once the clock has been set, you can select the
current time.
✎
The clock must be reset every time the power is disconnected.
Setting the Clock using Digital Broadcast Info
→ → →
System Time Clock
Set Clock Mode to Auto. The TV automatically downloads the correct time from a digital channel. To enable this
option, the TV's Antenna jack must be connected to either an antenna or a cable output and must be receiving digital
broadcasts. The accuracy of the time information received may vary depending on the channel and signal. If your TV is
connected to a set-top-box or satellite box using HDMI or Component connections, you must set the time manually.
✎
Availability depends on the specific model and area.
If the Clock is Wrong in Auto Mode...
System → Time → Clock →
If the time set automatically is incorrect, you can offset the clock in 1-hour increments by as much as -/+ 12 hours.
→ →
Select System Time
✎
Time Offset adjusts the time through network connections and is only available if the
and the TV is connected to the Internet though a local area network.
✎
Time Offset will adjust the time if the TV fails to receive time information through normal digital broadcast signals.
Setting the Clock Manually
Manually enter the time. Set
Clock Set: Set the current
Time Zone: Select your time zone.
✎
This function is only available when the
DST: Switches the DST (Daylight Saving Time) function on or off.
✎
This function is only available when the
GMT: Selects your time zone.
✎
When Country is set to others, you can use this function.

Setting the Time and Using the Timer

Clock Mode
Time Offset
→
Clock Time Offset and offset the clock to the correct time.
Clock Mode to Manual and then select
Date and Time.
Clock Mode
Clock Mode
English - 111
Clock Set to enter the current time and date.
is set to Auto.
is set to Auto.
INFO button to check the
Clock Mode is set to Auto