Samsung T24D390SW User Manual page 95

Preference Features
When Aerial Source is set to Terrestrial or Cable
Digital Channel Tuning
•
Scans for a digital channel.
1. Select the New.
✎
When selecting Aerial
✎
When selecting Aerial
2. Select the Search. When scanning has finished, a channel is updated in the channel list.
• Analogue Channel Tuning
Scans for an analogue channel.
1. Select the New.
2. Set the Programme,
3. Select the Store. When scanning has finished, a channel is updated in the channel list.
Channel mode
P (programme mode)
•
When tuning is complete, the broadcasting stations in your area have been assigned to position numbers from P0 to
P99. You can select a channel by entering the position number in this mode.
• C (aerial channel mode) /
These two modes allow you to select a channel by entering the assigned number for each aerial broadcasting
station or cable channel.
Fine-Tuning the Screen
Broadcasting → Channel Settings
✎
Available for analogue broadcasts only.
Analogue pictures can become shaky and full of noise. If this happens, you can fine-tune the signal and/or reduce noise
to clear up the picture.
1. Select Channel Settings
2. Press the or button to make adjustments. Select
¡ £
reset the Fine-Tune operation.
→ Terrestrial: Channel, Frequency,
→ Cable: Frequency, Modulation,
Colour System, Sound System,
S (cable channel mode)
→ Fine Tune
→
Fine Tune. An adjustment bar appears on the screen.
Bandwidth
Symbol Rate
Channel and Search.
Save or Close to apply the new setting. Select
English - 95
Reset to