Brita Hydration Station 2500.CT Owner's Manual
Brita Hydration Station 2500.CT Owner's Manual

Brita Hydration Station 2500.CT Owner's Manual

Counter-top

Advertisement

1455 Kleppe Lane Sparks, NV 89431-6467 (888) 909-4297
Counter-top Brita
For complete warranty information, please see page 10 of this owner's manual.
SHOULD YOU EXPERIENCE DIFFICULTY WITH THE USE OF THIS MODEL, OR
REQUIRE REPLACEMENT PARTS, PLEASE CALL:
HOURS OF OPERATION: MON-THURS 7:00a.m. - 4:00p.m. PT, FRI 7:00a.m. - 1:00p.m. PT
QUICK START REFERENCE (SEE INSTALLATION INSTRUCTIONS FOR FURTHER DETAILS)
RATED SERVICE FLOW: 0.55 GPM (2998L/day) OPERATING TEMP: 35-100
FILTER CAPACITY: 1500 gallons (5678L) or 12 months
REPLACEMENT CARTRIDGE: Brita
WATER SUPPLY REQUIREMENTS: 88 PSI (5.99 ATM) max supply pressure; cold water only.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
NOTE: When installing this unit, all pertinent local, state, or federal codes should be adhered to.
This unit is certified for indoor use only.
© 2015 Haws
®
Corporation – All Rights Reserved
HAWS
®
and other trademarks used in these materials are the exclusive property of Haws Corporation.
The BRITA trademark and logo are registered trademarks of Brita LP and used under license by Haws Corporation. All rights
reserved.
02/15
website:
www.BritaHydrationStation.com
Model 2500.CT
®
Brita® Hydration Station®
Limited Warranty
TECHNICAL SUPPORT:
1-800-766-5612
®
Filter Model 6441
Model 2500.CT
OWNER'S MANUAL
Hydration Station
No. 2077014 (6)
®
°
F (1.7-37.8
°
C)
Page 1 of 11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hydration Station 2500.CT and is the answer not in the manual?

Questions and answers

Summary of Contents for Brita Hydration Station 2500.CT

  • Page 1 HAWS ® and other trademarks used in these materials are the exclusive property of Haws Corporation. The BRITA trademark and logo are registered trademarks of Brita LP and used under license by Haws Corporation. All rights reserved. 02/15 Model 2500.CT...
  • Page 2 Improper use of the Brita Marks may be considered a violation of these Trademark Usage Guidelines, and Brita, LP reserves all rights to enforce proper use of its trademarks, including but not limited to having you remove or cover up the Brita Mark on the product.
  • Page 3: Installation

    Removal of this label signifies you or an appropriate owner’s agent will comply with all BRITA® Trademark Usage Guidelines as well as maintain the unit to the standards as first installed. Detailed information noting requirements can be found in the Owner’s Manual.
  • Page 4 Remove the top lid of STEP 2: the cooler. Unscrew the 3 Phillips screws that hold down the internal lid and lift it out of place. This will expose the filter area. Locate the tubing STEP 3: running into the float valve on the cooler tank (see diagram).
  • Page 5 Install the tubing attached to the pressure regulator outlet into the inlet on the back of the STEP 5: cooler. Tubing may be shortened if so desired. NOTE: The regulator protects against sudden pressure increases in the supply line. Provide a water supply inlet of 1/4" tubing with a code-compliant shutoff valve (valve and STEP 6: tubing not supplied).
  • Page 6 Remove the top cover from the unit, and then carefully pry the circular lid off of the water tank. STEP 9: On the underside of the lid are two floats – the larger float is the main float that closes the water inlet valve when the tank is filled.
  • Page 7: Operation

    Operation Dispensing Cold Water To dispense cold water, press the “Cold” button; the ring around the “Water” button should turn blue. Press and hold the “Water” button to dispense; release the button to stop dispensing. Dispensing Hot Water To dispense hot water, press the “Hot” button; the ring around the “Water” button should turn red.
  • Page 8: Troubleshooting

    Troubleshooting ® HYDRATIONSTATION ® TROUBLESHOOTING BRITA PROBLEM REPAIR CHECKLIST Water is not dispensing. Verify power and water to the unit. Check that the float assembly is not tripped – remove top lid from unit and press the red reset button on the valve in the lid of the tank –...
  • Page 9: Performance Data Sheet

    PERFORMANCE DATA SHEET IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs. It is recommended that, before purchasing a water treatment unit, you have your water supply tested to determine your actual water treatment needs. Substance Influent Challenge Reduction...
  • Page 10 BRITA HYDRATION STATION   LIMITED WARRANTY    TERMS AND CONDITIONS.   This warranty is provided by Haws Corporation (Herein referred to as “HAWS”). This warranty  provides for, at HAWS’s sole discretion, the entire replacement of a Point of Use Water Cooler (Herein referred to as “POU  Cooler”) deemed defective or replacement of just the defective parts of the POU Cooler in question. This Limited Warranty  does not provide for any labor allowances to Dealer to repair defective POU Coolers. This Limited Warranty does not offer  coverage for components that are not factory installed such as dealer‐installed accessories not originally sold by manufacturer.  Customer agrees to notify HAWS in writing if any nonconformity, defect, damage, contamination, or problem with the POU  Cooler.   INSTALLATION AND OPERATION.   This Limited Warranty applies only when the POU Cooler is installed and operated in  accordance with HAWS’s written instructions included with each unit. It does not apply to POU Coolers, which on examination  by HAWS have been subjected to accident, modifications, reconditioning, abuse, misuse, misapplications, corrosive type  atmospheres, abnormal use or damage from shipping and handling.  Warranty Coverage:    FIRST TWO YEARS:   HAWS warrants the complete POU Cooler including compressor, hermetically sealed  refrigeration system, faucet or faucets, and electrical components (cold control, compressor, overload/relay, heat band, and  hot controls) to be free from defects in material and workmanship under normal use for 2 years (24 months) from the Invoice  date. HOWEVER, the Float Assembly with tubing is warranted for 1 year (12 months). No increase or alteration, written or  verbal, of this warranty is authorized.    THIRD YEAR:   HAWS warrants the following system and components to be free from defect. Coverage is limited to  replacement of defective component or replacement of complete POU Cooler at HAWS’s option, in any case, the value of the  Warranty shall not exceed the purchase price paid for the POU Cooler.  REFRIGERATION SYSTEM   Includes replacement of the following listed parts: compressor, evaporator,  condenser, connecting refrigerant lines and drier.  Minor Repairs.   Upon notification of a defective part and POU Cooler serial number by dealer, HAWS will replace the parts free  of charge either providing the actual parts as replacement, or issuing credit for the purchase price of the part to the dealer  within 30 days. Dealer acknowledges that it must have only qualified technicians, as defined by state and local codes, perform  any parts replacement or else the warranty set forth herein will be voided. Any labor charges and shipping costs associated with  minor repairs will be the responsibility of the dealer.  Major Repairs / Refrigeration (Sealed System Repairs).   Upon notification (to include the serial number and reason code for  the major failure) of a major defect in the refrigeration system, HAWS will provide dealer a replacement POU Cooler with a one  (1) year limited warranty, on the same terms and conditions as contained herein, at no charge on customer’s next order. Dealer  must hold POU Coolers with major defects for 30 days in the event HAWS personnel need to inspect the coolers. Dealer may  thereafter dispose of the POU Coolers at dealer’s expense.  CUSTOMER’S OBLIGATIONS.   Customer must provide proof of installation date when repair is required. The Customer also has  the obligation and responsibility to return the complete unit to the owner’s equipment or service center or closest authorized  distributor (HAWS at www.BritaHydrationStation.com ; or 800‐766‐5612), if the compressor, refrigeration or water system is ...
  • Page 11: Technical Support

    HAWS ® and other trademarks used in these materials are the exclusive property of Haws Corporation. The BRITA trademark and logo are registered trademarks of Brita LP and used under license by Haws Corporation. All rights reserved. 02/15 Model 2500.CT...

Table of Contents