Toyotomi TKN-A28DV User Manual page 41

REMOTE CONTROLLER
3. Press the ON/OFF button to start the air conditioner. The temperature can be set within a range of
o o o
17 C~ 30 C in 1 C increments
NOTE
In the Dehumidifying mode, you can not switch the fan speed. It has already been automatically
controlled.
Adjusting air fl ow direction
Use the SWING and DIRECT button to adjust the desired airfl ow direction.
1. When push the DIRECT button, the horizontal louver changes 6 degree in angle for each push.
2. When push the SWING button, the louver will swing up and down automatically.
NOTE
When the louver swing or move to a position which would aff ect the cooling or heating eff ect of the air
conditioner, it would automatically change the swing/moving direction.
Timer operation
Press the TIMER ON button can set the auto-on time of the unit. Press the TIMER OFF button can set the
auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote controller shows TIMER ON, the last Auto-on setting time and
the signal «h» will be shown on the LCD display area. Now it is ready to reset the Auto-on time to START
the operation.
2. Push the TIMER ON button again to set desired Auto-on time. Each time you press the button, the time
increases by half an hour between 0 and 10 hours and by one hour between 10 and 24 hours.
3. After setting the TIMER ON ,there will be a one second delay before the remote controller transmits the
signal to the air conditioner. Then, after approximately another 2 seconds, the signal «h» will disappear
and the set temperature will re-appear on the LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote controller shows TIMER OFF, the last Auto-off setting time
and the signal «h» will be shown on the LCD display area. Now it is ready to reset the Auto-off time to
stop the operation.
2. Push the TIMER OFF button again to set desired Auto-off time. Each time you press the button, the
time increases by half an hour between 0 and 10 hours and by one hour between 10 and 24 hours.
3. After setting the TIMER OFF ,there will be a one second delay before the remote controller transmits
the signal to the air conditioner. Then after approximately another 2 seconds, the signal «h» will
disappear and the set temperature will re-appear on the LCD display window.
CAUTION
The eff ective operation time set by the remote controller for the timer function
is limited to the following settings: 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0,
5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13, 14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24.
41
GB