Table of Contents
Advertisement
Appendix
Care
¤
Wipe the charging cradle and the hand-
set with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause a build
up of static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove the
battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open and
the keypad facing down in a dry, warm
place for at least 72 hours (not in a mi-
crowave, oven etc.).
4. Do not switch on the handset again un-
til it is completely dry.
When it has fully dried out, you will normally
be able to use it again.
Questions and answers
If you have any questions about using your
handset, visit us at any time at
www.gigaset.com/customercare. The table
below contains a list of common problems
and possible solutions.
Registration or connection problems with a
Bluetooth headset.
¥
Reset the Bluetooth headset (see the user
¥
guide for your headset).
Delete registration data from the handset
¢
when de-registering the device
¥
(
page 27).
¢
Repeat the registration process
(
page 27).
The display is blank.
1. The handset is not switched on.
2. The battery pack is flat.
The keys of a handset do not respond when
pressed.
¥
The keypad lock is activated.
"Base station x" flashes on the display.
!
1. The handset is outside the range of the base
2. The handset has been de-registered.
3. The base station is not switched on.
Base Search flashes in the display.
The handset is set to Best Base and no base sta-
¥
tion is switched on or within range.
¥
Handset does not ring.
¥
The ringer tone is switched off.
The other party cannot hear you.
You have pressed the
¥
is "muted".
You hear an error tone when keying an input
(a descending tone sequence).
¥
Action has failed/invalid input.
¥
Press and hold the end call key
¥
¢
Charge/replace the battery pack
(
page 6).
Press and hold the hash key
¥
station.
Move the handset closer to the base sta-
tion.
¥
Register the handset (
¥
Check the base station mains adapter.
Move the handset closer to the base station.
Check the base station mains adapter.
Activate the ringer tone (
u
¢
Switch on the microphone again
(
page 11).
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
First steps
a
.
¢
#
(
page 8).
¢
page 7).
¢
page 22).
(INT) key. The handset
29
Advertisement
Table of Contents
