How To Program The Ranger 8600E - CADDX Ranger 8600E Installation Manual

Downloadable control communicator

Hide thumbs Also See for Ranger 8600E:

User manual (6 pages)

Table of Contents

The Ranger 8600E can be placed into the "Program" mode by either of the following methods.

‰

Enter the 4 digit "Go To Program" access code (locations 28-31). At initial power-up the code in these slots is

[9][7][1][3]. The Ranger 8600E must be disarmed to gain access to programming with this code.

‰

Plug the optional Caddx Model 8950 programmer into the 4-pin male outlet marked "Program" on the Ranger 8600E

P.C. Board. See figure 3 on page 8.

When the system keypad is utilized for programming (as described by method 1 above), the Ranger 8600E will be in the

"Program" mode, and the yellow LED's will display the data in location 000. The data is displayed using a Binary system.

With this system:

ƒ The zone 1 LED equals "1" when illuminated.

ƒ The zone 2 LED equals "2" when illuminated.

ƒ The zone 3 LED equals "4" when illuminated.

ƒ The zone 4 LED equals "8" when illuminated.

Examples:

1. If the data in location 000 is "9", the LED for zone 1 (=1) and zone 4 (=8) would be illuminated. By adding the two

values together, (1+8=9) you would determine that the data in location 000 is "9".

2. If the data in location 000 is "6", the LED for zone 2 (=2) and zone 3 (=4) would be added (2+4=6) indicating the

data in that location to be "6".

3. If no LED's are illuminated, the location contains a "0".

To advance from location 000 through 255, press the [#] key. To go to a specific location, enter the location number

followed by the [#] key. The yellow LED's will then display the data in that location. Data is changed by entering a number

from 0 to 15 followed by [U] (U = data enter). Review the examples in figure 2 on page 8.

When using the optional Caddx Model 8950 Programmer, the programming keystrokes will be the same as with the system

keypad. The Caddx 8950, however, has the ability to display the location number and the data on the numeric display. See

figure 3 on page 8.

IMPORTANT FUNCTION CODES

[9]-[1]-[0]-[#]

When in the Program Mode, this function code can be used to write original factory default codes into

the 8600E.

[9]-[3]-[0]-[#]

This function code is used to exit the Program Mode after it was accessed via the keypad.

[2]-[3]-[0]-[#]

This function code is used to exit the Program Mode from the 9050 LCD keypad only.

To exit programming from the model 8950 Programmer, unplug from PC board.