Appendix 2 - Reporting Contact Id - CADDX Ranger 8600E Installation Manual

The 8600E has the ability to report Ademco Contact ID transmissions to either or both phone numbers. Each report in
Contact ID consists of an Event Code and a Zone or User ID. The zone or User ID is programmed in the first digit of each
report. When programming the event code (the second digit) for zones 1-8 (locations 105, 107, 109, 111, 113, 115, 117, or
119), programming a zero will cause the event code to follow the zone type for that zone. The event code for the zone type
can be overridden by programming a digit from the table below. Duress (location 87), AUX 1 (location 89), AUX 2 (location
91), and keypad Panic (location 93) must be programmed from the table below:
Programmed Event Code
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
The following reports will send fixed event codes regardless of the number programmed in the event code location:
Event
Keypad Tamper
Download Complete
Autotest
Failed to Communicate
Closing
Opening
AC Loss
Low Battery
Trouble
Bypass
Restore
Cancel
Maintenance Open
Maintenance Close
Exit Error
Recent Closing
Auxiliary 3
User on site
* This will send the event code for the zone restored.
APPENDIX 2 - REPORTING IN CONTACT ID
Contact ID Code
122
110
120
130
131
132
133
134
135
150
121
100
123
137
602
300
Contact ID Code
137
412
602
354
401
401
301
302
380
570
*
406
401
401
138
401
140
605
33
Description
Silent Panic (for Loc. 93 only)
Fire Alarm
Panic alarm
Burglary Alarm
Perimeter Alarm
Interior Alarm
24-hour Burglary
Entry Alarm
Day/Night Alarm
Non-Burglary 24-hour
Duress Alarm
Medical Alarm ( Not used for UL )
Audible Panic Alarm
Tamper Alarm
Periodic Test
System Fault
Event Code Location
95
97
99
101
102
103
121
123
124
125
126
127
172
173
210
211
253
254